Serpentine Belt
Under the hood should be a diagram of the belt, this is your best reference without the service manual. All you have to determine is which direction to rotate the belt tensioner, and then put the belt back on as shown in the diagram.
If it is not you can run down to your nearest auto parts store and they can print it out for you or just buy the Hayes or chilton manual on your car. It only cost a few bucks and it well helps you out later down the line if something else brakes.
Relieve Serpentine Belt Tension.
Before removing the belt, note its routing around all applicable pulleys for ease of installation.
1. Using a box end wrench on the tensioner pulley center bolt, rotate the tensioner assembly clockwise.
2. While holding the tensioner in this position, remove the alternator drive belt from one or two of the applicable pulleys.
Use a box end wrench to rotate the tensioner pulley assembly clockwise to relieve serpentine belt tension
1. Slowly release the tensioner, and remove the box end wrench from the center bolt.
2. Remove the alternator drive belt from the remaining applicable pulleys.
To install:
When installing the drive belt on the pulleys, ensure that it is properly seated in all of the pulley grooves.
1. Using the box end wrench, rotate the tensioner clockwise again, then position the drive belt on all of the pulleys.
2. Slowly release the tensioner until it eliminates all drive belt slack.
3. Inspect the tensioner indicator to be sure that the belt is properly tensioned. If the belt tension is incorrect, the belt should be replaced with a new one, or, if installing a new belt, the belt may not be the correct belt for your vehicle.
4. Then start the engine. Ensure that the drive belt works properly.
I need the drivebelt routing for white outdoor 42" mower
42" deck = 71" belt48" deck = 73.8" belt44" SNOWBLOWER uses V-Belt 131"
Most LT12H mowers take a #213676 OEM belt or #6885 Gates belt for the blade application
I have Murray 42" cut riding mower that the belt came off. How do I put the belt back on?
026013673
Belt is stretched or the tension pulley
The belt length for a Craftsman tractor LT 4000 42 is 96 inches by three-quarter inch. This is assuming the same 42 inch mower deck is still in use.
how do you rout a belt for 42 inch master cut 13aj7955059
you were no help
A John Deere belt diagram can be found in an owner manual. The manual should have all the diagrams, and other information for the tractor.
In the 2013 movie 42, Rickey was portrayed by Harrison Ford.
42 years old