They sell halogen replacements for the bulb VW used on the Beetle, Bus and other aircooled cars. They work much better, and it's just like changing a regular headlight--pull off the trim ring, undo three screws, remove the retaining ring and the old headlight, plug in the new one and reassemble the car.
lower the tail gate on the truck. there will be 2 torqx head screws removed the screws it will loosen the inside of the tail light assy... pull on the tail light assy strait back. the light assy should come out turn the bulb casing on the back of the light assy and pull the bulb out.
open the hood, stare at the head light assy, the head lights are in place by two long pins in the top portion of the assy, twist and pull up on the latches, ta-da the head light assy will come out, reach in and replace that 1.99 bulp popeye! Consult the owners manual. It will tell you how to access the headlamp for replacment.
Remove the securing Phillips head screw on the lamp assy. to be removed. The light assy. also has a hidden securing plastic stem and rubber grommet which goes dry behind the light assy. Gently pry light assy. out. If possible spray WD-40 from the engine compt. side first to try and lubricate the rubber grommet. When lamp assy. is removed you can then replace the lamp by undoing the plug at the rear.
I have a 92 PA. I had to remove the head light assy which gave access to that bulb. There are two thumb like screws to remove that assy. Hope yours are the same as mine.
pull the whole light down from the head liner (it is just held on by 2 clips it will not break )then you pull the light itself from the holder change it and reinstall the complete light assy. to the head liner
the hood must be open to get to two clips that hold the head light assy in place on the back side of rad core support pull them up then light assy will tilt fwd then you unplug the wire to the light you want to replace install in the rev order
I made a video on how to change the head lights in my jetta This is for a 2006 jetta tdi, but other years apply http://www.truezombielife.com/2006-jetta-head-light-replacement/
Yes. Make sure you ask for a replacement unit that still used the controls.
On my 92 PA, they were fight on top of the head light assy. They are about the size of a quarter and are made out of plastic.
remove 2 Phillip head screws pull out bulb replace it
Three Phillips head screws hold on the entire assy. There are two on the side and one on the bottom. You may need a flashlight to see them because they are recessed and black. To see the one at the bottom you look between the bumper and the bottom of the light assy. Once the screws are removed just pull straight out to release the rubber grommets.
open hood and look at top of head light you will see a screw on 2 sides remove both and light assy will come out if screws will not come out (happens alot) seek prof help