answersLogoWhite

0

  • Ford Taurus
  • Nissan 300ZX
  • Ford Escape XLT
  • Ford Explorer Sport

After starting your 1985 300zx it idles for about 2 minutes then shuts down Also changed the idle sensor Help?

User Avatar

Wiki User

βˆ™ 2006-09-08 21:34:39

Best Answer
Copy

Check fuel filter and fuel pump.

2006-09-08 21:34:39
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Your Answer

Loading...

Related Questions

Where the nock sensor in 300zx motor?

diagram of a nock sensor in a 300zx 1996


1993 300zx sensor?

what sensor?


How do you test a Crankshaft Sensor in a 1986 Nissan 300ZX?

Using a scanner with a scope, you can view the output wave of the sensor as you crank the engine.


Settings on a 1993 300zx crank angle sensor?

Refer to your manual. Buy a Chiltons.


Where is the mass air sensor 300zx?

On the 89- 300zx the mass air flow sensor is located under the panel that is between the head lights. remove the panel and you will find the air filter box. the maf is bolted directly to the filter box


Where can you find a diagram for the location of the coolant sensor for a 1986 300ZX?

The 300ZX Shop Manual has one page visual for all the components, the sensor located on the drivers side just to the right side of the Distributor. Its screwed into the block near the top of the block and has two fine wires coming out of the sensor.


How do you locate the knock sensor on a Nissan 300zx twin turbo and is it easy to change?

The knock sensor on 90-96 300ZXs is located between the engine block and lower intake manifold. please if you want to know where anything is at on a 300ZX visit www.ttxtz.com


Why does your Nissan 300zx runs rough on start up?

mass airflow sensor of head tip sensor could also be catalytic converter


Where is the crankshaft sensor on 1990nissan 300zx?

it is on the front of the engine near the driver side intake tube


Where is the iat sensor located in 300 zx non turbo 1987?

i can't find the iat sensor for my 1987 nissan 300zx non turbo


Where is the knock sensor on a 1991 300zx 2 2 non turbo?

The knock sensor on Nissan 300ZX non-turbo from 1990 thru 1996 is located below the lower intake manifold on the rear of the engine block. To replace the knock sensor the upper and lower intake manifolds need to be removed. It is always best to replace the knock sensor with a new one considering its major dissasembly.


1986 300zx turbo 2 plus 2 runs rough first few minutes?

try a new fuel filter, I had mine towed it wouldn't run 5 feet. Changed the fuel filter, MAGIC!


Will unhooking the turbo on a 1985 datson 300zx stop it from starting?

no, but it will lose alot of power


Where is the knock sensor on the 90 Nissan 300zx non turbo model?

underneath the intake plenum near the rear of the engine.


What is the cost to have a mechanic replace a cylinder head temp sensor for a Nissan 300zx?

more than the miserable car is worth


Where is the Cam shaft sensor located 1992 Nissan 300zx?

It is located on the center, top, rear of each cylinder head.


Where is the compass sensor located at on a 1986 Nissan 300zx?

at the rear intersection of the T-top bar with the rear cross bar.


Where is the fuel temp sensor on a 1987 Nissan 300zx none turbo?

no the 85 it is on the fuel pressure reg it should be the same


Where is the air regulator in a 1990 300zx non turbo?

Located in the back of the engine on the driver's side next to the O2 sensor connector.


How do you fix the speedometer on a 1985 300zx its stuck at zero?

If the odometer isn't working as well, it means the cable snapped. It runs from the passenger side of the transmission to either the speed sensor or behind the dash. Havent changed one in a few years, theyre not that expensive on eBay.


How do you set the time on a 1990 300zx clock?

In mine there is a button for hours and a button for minutes right beneath the display.


If your 86 300zx turbo runs better when its cold then after about 5 minutes of running could that be a problem or is that just how these cars run?

02 sensor clean air intake check fuel pump check turbo engine temp cooling fan check cat


Where is the Crank Sensor located on a 1984 Nissan 300ZX 2 plus 2 non turbo?

Update: The optical crankshaft sensor is located inside the distributor, which is on the top front of the engine on the drivers side.


Where is the crank sensor 1990 300zx?

Looking at the engine on the right ride. Its going to be the round object where the timing cover stops on front of the engine.


Why does your warning light for cooling system stay on on your 1984 Nissan 300zx?

You are low on coolant or the low coolant sensor/wiring/connection is bad.