answersLogoWhite

0


Best Answer

check the fuses first, there should b a fuse for the instrument panel check the fuses first, there should b a fuse for the instrument panel

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: All gauges on 1994 olds cutlass supreme do not work what do you replace dash or wires?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Wiring diagrams for a 1983 cutlass supreme?

what wires do i need to hook up to the alternator


How to do a tuneup 1984 cutlass supreme tune up?

replace the distriburetor cap and the rotor, new plugs and plug wires, new fuel and air filters, and reset the timing and set the idle speed.


Where is the location of the spark plugs on a 3.4 DOHC engine for a cutlass supreme?

They are screwed into each head. Follow the plug wires.


Where is the ignition coil on 1988 cutlass supreme 2.8?

Follow the spark plug wires to the rear of the engine and you will find the coil packs.


How do you replace the alternator on a 98 Oldsmobile Cutlass?

Remove serpentine belt, remove three bolts ,an 2 wires. The alternator will pull up off the motor to remove. Put new alternator in replace bolts, replace wires, an replace the serpentine belt..


How do you replace the turn signal switch on a 1985 Cutlass Supreme?

Remove steering wheel (with wheel puller), remove lockplate (with lockplate remover), remove 3 screws that hold turn signal switch, unplug switch at bottom of column, fish out the wires, install new switch, fish in new wires.


How do you locate the starter on a 93 Oldsmobile Cutlass supreme?

it is located at the front of the engine under the coil packs(where the spark plug wires all connect)


Where is brake switch on 96 olds cutlass supreme?

It's a white plastic thing right above the brake pedal. It has two wires that plug into it.


Why does my 97 Oldsmobile cutlass supreme miss when going uphill?

Could be in need of a tune up. Start with replacing the spark plugs and spark plug wires.


How do you replace a starter on a 85 cutlass?

The starter on a 85 Cutlass is replaced by disconnecting the battery, unbolting the starter, disconnecting the wires at the starter, and removing it from the vehicle. The new starter is then wired up and bolted to the engine block.


Why are your gauges going up and down?

Gauges are generally tuned to tension on wires, if they gets tweaked the gauges can easily become faulty.


1995 olds cutlass supreme is jumping between 2000 and 3000 rpms when driving 55 mph?

I had the same Problem on my 94... try replacing the spark plug wires.