Remove steering wheel (with wheel puller), remove lockplate (with lockplate remover), remove 3 screws that hold turn signal switch, unplug switch at bottom of column, fish out the wires, install new switch, fish in new wires.
i need to replace the ecm on a 1993 olds cutlass supreme,can i replace it with another ecm from another olds cutlass?
its in the steering colume replace the turn signal switch
On the 94 and 95 you just pull it out. Be careful with the wiring connector.
If its a Olds Cutlass Supreme, its a fairly easy process. Grab the turn signal stalk firmly near its base. Gently wiggle, and slightly twist while pulling it out. Replace with the new stank and plug in the small plug at the base of the stalk. And your done If you are talking about a Olds Cutlass Ciera, its not a easy process, and I pay to get it done.
Take your steering column apart. Best thing to do is go out and spend the 30 or 40 dollars on a haynes or chiltons book. That will tell you step by step how to do it.
Very likely it's the turn signal switch.
I HAVE A 1992 OLDS CUTLASS SUPREME JUST BE FOR it warm up it cuts off
Replace headlight switch- dimming rheostat may be loose
One of two things. Either the brake light switch behind the brake pedal. Or try wiggling or rotating your turn signal stalk in a circle motion. If the brake lights work when the turn signal stalk is wiggled then you need to replace the turn signal stalk.
i had same problem on my 94 cutlass supreme...long story short, it was the ignition switch. $300. at shop.
The 1994 Oldsmobile Cutlass turn signal relay switch can be found below the dashboard. The relay switch will be on the drivers side of the passenger compartment.
The oil pressure switch on a 1995 cutlass supreme is located under the hood front center of the oil pan. It is right beside the oil filter.?æ