0
3 quarts
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Should a shaft-drive 1986 Yamaha Maxim 700cc be at approx 3500 rpm at 45 mph in fifth gear?
Sounds about right. It will be at about 4700RPMs at 60MPH in 5th.
What is a vehicle speed sensor drive gear?
Its the gear that connects the speed sensor shaft to the transmission
Does a seized drive shaft prevent a car from going in gear?
no .. Having a seized drive shaft would be like just having the brake on .. will still go in gear .. just wont move ..
What causes dist shaft drive gear wear 1994 Ranger 3.0?
Check the gear on the cam shaft, you can see it through the hole that the distributor mounts in.
Can a 2 wheel drive and a 4 wheel drive pitman arm shaft to gear box seal be the same?
It could, if they have the same gear box.
What is the torque specs for drive gear on a 2005 Yamaha Virago 250?
7.2 ft lbs as per the Yamaha repair manual
What does drive shaft do?
A drive shaft is hooked to the transmission and turns when the vehicle is in a gear position other than park or neutral. The turning drive shaft helps the rear axle turn the rear wheels so the car can move.
How does a car drive shaft operation?
when the car engine is start and the driver shift a gear,the power front the engine transfer to the drive shaft and its transfer the torque or power to the axle shaft the move a wheel.
What is the formula of a driven gear and a driving gear?
Turn the drive gear 1 complete turn, and count how many times the driven gear turns. For example, to figure out the rear end gear ratio if the drive shaft turns once and the rear turns 3 and a half times you have a 1:3.5 gear ratio. This means the rear wheels turn 3.5 times for each one turn of the drive shaft.
What is it geared drive?
A gear drive uses gears to drive the camshaft vs a belt or timing chain. Some bikes use a shaft drive vs a chain that is often confused with a gear dive.
How do you change a driveshaft on a saxo vtr?
Remove drive shaft holder clamps round by the gear box undo off hum get wishbone down and pull drive shaft out
If the driven shaft and the drive are at the same angle but turn in opposite directions the gearing system is called a?
gear and pinion drive
