located ot the lower front of engine above motor mount 2 of them very tough job without a lift
Yes
Check out the related link for a video on how to replace a crankshaft position on a Ford Focus SE.
Check out this link. It has all the info you need http://www.freeengineinfo.com/cadillac-northstar-starter-replacement.htm
Cadillacs and the northstar engine are notorious for squeaky belts. if i were you i would not do it yourself. take it to a dealer mechanic.
how to replace the crankshaft position sensor located in a 2003 kia rio
Replace the crankshaft and camshaft senors and then clear the codes with an oBD II engine scanner and that will fix it.
The 2000 General Motors/Cadillac Deville came equipped in the 4.6L Northstar engine. Removing the main belt will require depressing the tensioner to free it. The new belt can then be routed across the accessory drive pulleys. The OE AC Delco belts for this application are 6K815 and 3K243.
where is the crankshaft position sensor on 2.5 liter vw jetta
Yes
car must be lifted its not a simple job as the compressor comes ou the passenger side wheel well.
The crankshaft position is on top of the transmission bell housing on the drivers side. The sensor can be replaced by unbolting and unhooking the plug.
1983 doesnt have a crankshaft position sensor. you have an ignition module located on the side of the distributor.