There is an ignition lock cylinder forsale on Ebay right now that will fit. The average price is between 120.00 and 200.00. I am going to pull the part my self at a local junk yard. The part will cost less than 5.00. However you will need some specailized tools such as a steering wheel puller ,torx bit screw drivers, large sockets, breaker bar, hammer, punch and needle nose pliers. The job itself is relatively easy except for breaking the heads off the two screws that hold on the lock cylinder.
To change the ignition lock cylinder in a 2001 Chevrolet Tracker, first disarm the air bag system. Then remove the clock spring assembly to be able to remove the old ignition lock cylinder and replace with a new.
How I can replace ignition switch cylinder from Isuzu Rodeo?.
You can replace the ignition lock cylinder in your 1994 Pontiac Firebird without removing the steering will. Remove the retaining ring at the top of the ignition cylinder. The ignition cylinder will slide out.
== ==
No, not if it is not defective. If the ignition switch is defective then that is all you need to replace.
how do you replace ignition switch on a 1992 Chevy cavalier 2.2 4 cylinder
Replace the ignition lock cylinder.
Remove the retaining ring at the top of your Chevy S 10 ignition lock cylinder. Slide the ignition lock cylinder out. Remove the wiring harness from the back of the ignition lock cylinder. Reverse the process to install the new ignition lock cylinder.
Begin by removing the retaining ring at the top of your 1994 Ford ignition lock cylinder. The ignition lock cylinder will slide out. Remove the wiring harness from the end of the ignition lock cylinder. Reverse the process to install your new ignition lock cylinder.
The ignition lock switch is found under the steering column on a 2004 Honda Civic. Remove the steering column and ignition switch. Loosen the mounting screws that hold the cylinder in place. Pull and replace the lock cylinder.
The tumblers in the key cylinder have most likely become stuck in the wrong position and you will have to replace the ignition key cylinder.
Begin by removing the retaining ring at the top of your 1996 Mercury Tracer ignition switch. The ignition lock cylinder will slide out. Remove the wiring harness from the end of the cylinder. Reverse the process to install your new ignition lock cylinder.