If you "blew" the oil filter that would mean most of if not all the engine oil was lost. If this happened major engine damage could occur, (as in an engine not turning over). If the engine will not crank the oil lite will stay on. There is no reset that I'm aware of.
On my 1996 tacoma I do not have a gas light for low gas.
It may not have anything to do with the oil. Go to Auto Zone and have the codes read and repaire them. GoodluckJoe
Filters don't change the color of light. They selectively absorb or transmit light based on its color. Anything that comes out of a filter must have been there before the light entered the filter.
did you change the wires also. if not you probablly have a loose wire for one of the plugs. does it run any different
After resetting the fuel light on a 200 series do you have to drain the filter or do anything else?
The GE gswf filter needs to be changed periodically. There is usually a light indicator inside the refrigerator which turns red when the filter needs to be changed. For more information, consult the manual for your GE refrigerator.
Red. As the filter will only allow red light through, it, you can not see anything but reds.
o2 sensor out of range, misfire if running rough, too lean injector , fuel filter???
Anything that could cause a cylinder misfire can cause the check engine light to flash. A restricted fuel filter is one.Anything that could cause a cylinder misfire can cause the check engine light to flash. A restricted fuel filter is one.
Usually indicates a problem in the emission control system - have vehicle scanned to determine the problem
Resetting the maintenance light on a 1999 Toyota Tacoma is very easy to do. To reset the light, take the battery cables off for up to one minute to reset the light.
Yes