you need to remove or loosen belt tensioner assist bolt that is attached to the top of the alternator
The 2003 Dodge Stratus came optionally equipped in a 3.0L V6 engine. The first step is the disconnection of battery cables. Second, the serpentine drive belt can released and removed. Last, the two bolts holding the alternator to engine mount can be removed and replacement. The OE alternator for the 3.0L application is AC Delco #3341420.
It is located in the front passenger side of the vehicle at the top. It will be mounted with one black bracket at the top and two bolts at the bottom. It is at the highest point of anything else connected to the belts.
The alternator on a 1993 Dodge is regulated by the engine computer. You would have to find an aftermarket regulator and follow it's wiring schematic.The alternator on a 1993 Dodge is regulated by the engine computer. You would have to find an aftermarket regulator and follow it's wiring schematic.
drive belts tensioner/under chassis
The PCM (engine computer) is the regulator.
it shouldnt but it will if the alternator is bad or it has worn belts or broken belts on it
remove belt, remove alternator plugs, then bolts. pull out alternator. then undo bolts for bracket and remove.
The 2000 Dodge Caravan alternator can be changed by removing the alternator belt. Remove the wiring harness from the back of the alternator. Loosen and remove the alternator retaining bolts. Install the new alternator by reversing the process.
Remove the wiring harness from the back of your 1996 Dodge Ram 1500 alternator. Remove the belt from the alternator. Remove the alternator retaining bolts. Reverse the process to install your new alternator.
If it's the alternator belt, loosen the bolts holding the alternator in place, then use something like a hammer handle to pry the alternator away from the engine which will tighten the belt. Hold the pressure on the alternator while tightening the bolts. This is a general procedure, not specific to 1996 dodge.
Top of the engine, on the passenger side.
Three: A timing belt and two serpentine belts. The timing belt drives the water pump and camshaft The serpentine belts drive the power steering, ac, and alternator.
It is on the rear lower of the belt side of the engine. You can find the alternator in the back by the firewall on the passenger side of the car. It is best to put the car up on ramps since it is not reachable from the top. You can follow the belts and one of the belts will lead to the back that is attached to the alternator.
open the hood of the car go to the alternator. there should be a bolt facing the firewall on the alternator this adjusts it. make sure the other bolts are loose first. good luck!
Serpentine belts are used on a Dodge Neon to operating the engine accessories like the alternator, water pump, and air conditioner compressor. The power is provided by the engine's crankshaft.
The alternator belt on a 1998 Dodge Neon is adjusted by loosening the retaining bolts and applying pressure to the side of the alternator with a pry bar. With the belt tight, the alternator can then be bolted down.
not enough info in question; there are 3different belts on the 95 - 99 dodge neon. Timing, Alternator, and the Power Steering is combined with the Air Conditioner Compressor