Your best luck with a hole that large is going to be if its against a hard surface in the pool, IE: floor area , wall area below water.
You have nothing to loose , your going to most likely need a great underwater glue and very large patch material, avail from a pool professional.
A good underwater glue and site is Union Labs, Inc. www.boxeradhesives.com
No more underwater Ice Hockey with a liner pool either.
They also have an email avail and can direct you to a dealer in your area or online site for purchase. good swimmng getapool.com
You may also want to visit mrstickys.com and check on their Underwater Glue. Visit the FAQ's that describe how to repair a pool liner underwater.
The relevant magnitude is mainly the black holes' mass. Since black holes are the result of collapsing stars, yes, there are black holes with the mass of a star.The diameter is usually taken as the diameter of the event horizon. This diameter is directly proportional to the mass; a supermassive black hole such as Sag A* has a diameter comparable to that of a large star.
Example sentence - My father sewed patched over the holes in my jeans which allowed me to wear them longer.
By the diameter of their event horizon.
4 and a quarter inches.
There can be no average diameter for a black hole due to the fact that all black holes are unique in size and diameter, reaching from the diameter of 18 billion suns tied together and less than half a star's diameter. they are all different sizes and no one actually knows for sure whether they are actually holes considering that they are completely invisible to all eyes. because their gravitational pull is so powerful that not even light escapes.
Pre-splitting holes are charged, whereas line-drilling holes are not. Pre-splitting holes contain less explosive than the rest of the holes in the blast area.The blast holes directly adjacent to the line-drilling holes are charged to about 50% of that of the rest of the blast area.The diameter of the holes in pre-splitting tend to be much larger than those in line-drilling. Pre-splitting holes diameter ranges from 50mm - 100mm for civil engineering purposes while larger holes are used (some larger than 300 mm) for mining.Line-drilling holes usually have a diameter less than 75mm.Pre-splitting spacing is about 10-20 times the hole diameter.Line-drilling holes are spaced about 2-4 times the diameter of the hole.The holes in line-drilling are spaced much closer together than those of pre-splitting.
Use something like Duct Tape to make a backing and fill the hole as much as possible with this. The use a putty knife to get the stucco material in the hole and to cover it, going up and down and side to side. You can then immediately paint over the patched spot, no need to wait on it to dry!
a 50 micron filter will have sieve holes of diameter 50microns... ie 0.00005m while a 25micron filter will have sieve holes of diameter 25miicrons=0.000025
They were the height of the shovel and the diameter of the shovel. Most of the shovels were five feet long, but one was slightly shorter.
It sounds like a woodpecker to me.
please see the chapter 6 of mass transfer operation book by treybal
No. Six lugs won't fit. The 10-lug rims that I know about have 2 sets of 5 holes which are on two different diameters. There is room between the holes on a 5 bolt 5" diameter pattern for another set of 5 holes at 5.5" diameter.