answersLogoWhite
Computers
Dodge Ram
Mitsubishi Eclipse
Computer Terminology

Can you ByPass the Computer System on a 91 Eclipse?

383940

Top Answer

User Avatar
Wiki User
2007-06-04 02:23:34
2007-06-04 02:23:34

nope

1

Related Questions

User Avatar

The Honda rev limiter is computer controlled. look into ECU flashing

User Avatar

will a 91 Mitsubishi eclipse body parts fit a 91 ford probe

User Avatar

It can, but some modifications have to be done. It's actually a common thing to do to put a 6 bolt head (head from an eclipse produced from 89 - mid 91) from a 1g eclipse (1st generation) into a 2g eclipse (2nd generation) due to several benefits. If its a head from a mid 91- 94, then its pretty much a direct swap.

User Avatar

uhhh can you be a little more specific?

User Avatar

Dodge does not use inertia/reset switches. The fuel system is computer controlled with relays.

User Avatar

Can't ,you need a new dizzy or dizzy internals

User Avatar

check for key lock left hand front door jamb

User Avatar

in the engine compartment on the firewall

User Avatar

91 pages, in the first three chapters.

User Avatar

No! As per the nutritional information they are actually 91% sugar

User Avatar

i own a 91 caprice the engine ecm computer is mounted in the passenger side kick panel behind trim..

User Avatar

subtract 1919 from 2010 91 If you have a computer your computer has a calculator you can use that

User Avatar

13974945 You do have a calculator on your computer.

User Avatar

the manifold will boltup but you need to get a new jpipe and oil/water lines, you can find all that in a kit on ebat fyi

User Avatar

There are two possible mounting locations for the computer in a 91 ford Ranger. One is behind the radio. The second is behind the passenger side kick panel.

User Avatar

That's called back-dating, and it's illegal. Other than that, you have pretty much answered your own question.

User Avatar

the computer module sets the ratio depending on operating modes,temperate sensor output. more information is in the chilton manual-fuel system.

User Avatar

You could if you had a donor car. The trans, computer, wiring, cooling system, etc... are all different.

User Avatar

can't. computer does it automatically.

User Avatar

It is part of the engine computer.

User Avatar

I really can't emagine why you would want to do such a thing. The standard rack and pinion will have to be installed also.

User Avatar

Remove both heater hoses from inlet & outlet of heater core. Connect these hoses together.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.