0
Can you show a pic of where the bolts for the intake manifold are on the ford expedition 2000?
Wiki User
∙ 12y ago
Here is a link that shows how to replace the intake manifold gasket. Bolt locations and torque settings. Hope this helps.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Intake manifold bolts torque ford windstar?
2000 3.8 Lower intake manifold (manifold to cylinder head) 1st step is 44 inch pounds, 2nd step is 89 inch pounds. This must be done in sequence.
Where does the vacuum hose on the intake manifold on a 2000 Malibu go?
I have a 2000 Malibu, I can help you out if you can give me some more info...where on the intake manifold are you referring to?
Where is the upper manifold gasket located on a 2000 Chevy s10?
Assuming this is a 4.3L engine, the upper intake manifold gasket would be between the upper intake manifold and the lower intake manifold.
Location of temp valve 2000 Ford Expedition?
Temperature Gauge Sending Unit The sending unit is located in the front section of the intake manifold in the vicinity of the thermostat.
Where is the intake manifold on a 2000 venture?
on top of the motor
Where is the intake manifold re 2000 maxima?
the intake manifold is located on top of the engine, the piece that look like the tubbing is intertwining.
How do you install a starter on 2000 Toyota Tacoma?
It is really easy. open the hood and from behind the air intake manifold losen two bolts and it will come right off. the bolts are either a 14 mm or a 17 mm.
How do you replace egr valve 2000 eclipse gt?
Unbolts the (2) 12mm bolts from the back of the Intake Manifold (next to the TB), take off and replace it with new gasket.
How do you fix intake manifold runner that is stuck open on 2000 Mazda MPV?
Replace idle air control valve. 2 10mm bolts and about 15 min. $100.00 at mazda.
Where are the spark plugs on a 2000 Mitsubishi Galant v6 and can you change them without much trouble?
My 2002 Galant has not had spark plugs replaced for over 100k due to where they are. Three are underneath the intake manifold. Yes...intake has to be removed. Not difficult now that I know. Lots of bolts and hoses need to be removed to lift the manifold.
How do you fix intake gasket on 2000 lasabre?
The only fix for a bad intake gasket is to remove the intake manifold and replace the gasket.
How do you access the rear spark plugs on a 2000 Hyundai Sonata?
In short there are three bolts (left, center, right) on the back side of the intake manifold. Remove these along with the top bolts and the accelerator cables to gain access to the rear plugs/wires.
