0
Car won't start fuel pump ok replaced relay it starts with gas in valve body but the pump won't come on when key is turned help?
Wiki User
∙ 12y ago
Try resetting the fuel pump safety switch which is in the trunk. Consult your Owners Manual for the exact location.
Hope this helps! Radioman
I had the same issue and after replacing sensors, regulators, relays, etc. car still wouldn't start! Finally picked up a used pcm/ecm module (electronic control module) at a salvage yard, plugged it in and car started up. Just to test I reconnected the old pcm/ecm and again car wouldn't start. Put back the replacement and car fired up. I've seen on the internet where people did the same as me, replacing fuel pump, sensor, relays, injectors, regulators and their car wouldn't start and they couldn't figure it out so I thought I'd share what worked in my case
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
The fuel pump relay on 93 Tracker starts clattering a few seconds after ignition turned on and car will not start - relay distributor cap and rotor have been replaced?
Hi, Could be the fuel pump if it just started or the fuse or relay. Steve H.
Bike won't start however when I remove the cover of the start relay switch and place my finger on the copper tab it starts without pressing the start switch Already replaced the relay it did not start?
sounds like you have a short,or a loose wire in the start switch,leaves a open circuit in the relay,hope this helps,ride on
1996 gmc sonoma V6 4.3 Liter FO Will not start when cold.Spray intake with starter fluid and it starts right up. Replaced cold start relay and fuel pump relay and it still doesn't start.?
Check fuel pump and fuel filter.
If your 1992 Explorer doesn't start and you tap on the relay switch under the hood and the truck starts is the relay switch bad or the fuel pump Both the pump and relay switch have been replaced?
You may have gotten a bad relay, or there may be a loose electrical connection at or close to the relay.
What is wrong when a car keeps trying to start after started?
If you mean that the starter keeps spinning after the vehicle starts), the solenoid/relay switch is not releasing. In the START position, the relay spins the starter to start the engine and should release when the key is moved from START to RUN. Probably needs to be cleaned or replaced.
What could be wrong if a 1992 Honda Accord LX will not start?
1992 Honda Accord wont startI just had to replace my main relay. My car wouldn't start either. Now it starts every time I turn the key.I have a 1989 Honda Civic. When it got hot, it would not start. I also replaced the main relay, which I found online for like 30 dollars, and replaced it myself. It was very easy to do and I have never had a problem since.
1990 Acura Legend it will turn but not start?
its probably the main relay that needs to be replaced
What causes your radio to turn off when the lights are turned on?
It's a relay. Which one it depends... I would start from testing headlights relay.
When you try to start your 94 Honda Accord you cant hear the fuel pump and it wont start sometimes you hear the fuel pump and it starts?
yes and i just replaced the pump and i checked the relay but sometimes it will start then i hear a cut back then the check engine light comes on
Starter relay for 1997 Chevy s10 pickup?
The starter relay feeds power to the starter when the switch is turned to start. The relay will be mounted either on the fender or on the firewall.
1997 Chevrolet Malibu doesn't start but then if relay is wiggled by engine under hood car starts can this be fixed?
1997 chev Malibu doesn't start but then if relay is wiggled by engine under hood car starts can this be fixed
97 Ford Ranger ignition clicks when trying to start it Starts after key is turned on many times-up to 100 Starter battery neutral safety switch are replaced Terminals grounds check What next?
first thing i wouldn't try to start the motor more than a few times, and then let the starter cool down, then try again. the starter solenoid may have bad brushes and need rebuilt, or the starter relay may be defective and need replaced.
