get another vehicle with the same motor and copy or work out your firing order line the motor on tdc on number one cylinder remove dizzy cap check rotor position and fit high tension leads in sequence
Mark them first with a marker and change one at a time
one at a time and make sure you mark em, that way you don't get lost
Mark and remove plug wires. Remove spark plugs and install new plugs. Reattach plug wire to correct plug.
Remove the doghouse, mark spark plug wires if they aren't already, remove spark plug wires, remove 2 screws holding the distributor cap in place. Installation is reverse of removal.
Replace the spark plugs, wires, distributor cap and spark plug wires.Chances are your vehicle is in need of a good tune-up. Mark adjust your timing
The most common reason would be bad spark plugs or wires. i hope this helps you. Mark Vacuum leak is more probable.
Distributor panel?? If you mean distributor cap, you first move the air intake going to the throttle body. Mark all spark plugs wires with the correct plug and unplug each one at the spark plug. Next you will find 2 screws holding the distributor cap. Remove both screws and and lift off the cap and wires while the wires are still connected to the cap. Take the spark plug wires off and place them onto the new cap in the same position you removed them. Put new cap on and tighten the screws and replace the wires to the correct spark plug. You should replace the wires and rotor button when you do this also.
Could be a lot of things like, needs tuneup, crossed spark plug wires, blown head gasket, vacuum leak.
Mark each spark plug wire with a piece of tape and draw a picture on paper to mark where each wire is connected on the distributer cap. Remove all the wires. Remove two Phillips screws on top. Pull distributer cap off and replace. Put wires back on acording to your drawing.
New plug new wires OEM 2 new coil packs Spark some clean on them master flow sensor
I lost the wiring colors codes but it's fairly easy. The key is to find out what the color codes are for the vehicle your connecting the radio to. After that, yellow and red wires on the 2500 are your positive and negative, and the remaining wires are Speaker wires - FRONT Left, FRONT Right, REAR Left, REAR right. Once your power wires are connected just connect speakers to each set of matching color wires and mark which speaker comes on.
I lost the wiring colors codes but it's fairly easy. The key is to find out what the color codes are for the vehicle your connecting the radio to. After that, yellow and red wires on the 2500 are your positive and negative, and the remaining wires are Speaker wires - FRONT Left, FRONT Right, REAR Left, REAR right. Once your power wires are connected just connect speakers to each set of matching color wires and mark which speaker comes on.