0
Could a bad crank shaft position sensor be a reason for a 1996 Mirage to crank but not start?
Wiki User
∙ 13y ago
Yes,among several other things that can go wrong,the CPS signals to the cars ecu (computer)the position and speed of the crankshaft.If it has failed,you fail to go!If it is faulty you could have sporatic start and stop cycles,i.e. you run it stop,you shut it down for 15 minutes it runs again.hope this helps
ohlord
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What happens when a crankshaft position sensor goes bad?
When a position sensor is going bad the engine could run rough, or cut off for no apparent reason. Or, the engine may not start at all.
2001 Mitsubishi mirage service engine light wont start?
If the 2001 Mitsubishi Mirage won't start and has the service engine light on, you probably have an issue with a sensor. This could be a problem with an electrical or oxygen sensor.
Can you see a picture of crank position sensor?
no u could not
Why is your wrangler not sparking?
Possibly caused by a bad Crank Position Sensor. Could also be the cam position sensor or the coil. They all work together.
Where is the crank position sensor located on a 1993 Infinity G20?
trying to replace crank position sensor but i have no ideal where to look it is 1993 infinity G20 could you help me find this sensor
Where is Camshaft Position Sensor located?
The camshaft position sensor is most likely located on the cylinder head of the engine. The location could vary depending on the manufacturer.
Will a camshaft position sensor make your 2002 jeep hard to start?
It could.It could.
If my cam sensor wiring is defective could that be a reason for my car dying on me?
It could be the cause.
What is causing rpm surges in a 2004 dodge ram 1500 4.7L?
Probable failed TPS (throttle position sensor).
Could a crankshaft position sensor get fixed?
Repairing a crankshaft position sensor would be difficult if not impossible depending on what is wrong with it. They are relatively inexpensive so replacing it is the best option.
Your 1992 Pontiac bonne stalls when its in drive and the rpm are low whats the reason for this?
sounds like flooding Could be the Crank Position Sensor, especially if it won't restart for an unpredictable period of time.
How do you fix a Chrysler PT Cruiser with a P0016 code?
Possible causes could be,Timing gear misaligned,Faulty crankshaft position sensor,Faulty camshaft position sensor,Engine oil dirty,Incorrect engine oil viscosity,Crankshaft position sensor circuit is open or shorted,Camshaft position sensor circuit is open or shorted,
