0
After much time searching I found out that not all 1990's has a crank sensor. Dodge used up some 1989 engines in the 1990 production, thus some do NOT have crank sensors.
I NEED HELP DIAGOSING THIS ONE! It runs great, then it will loose power, and smell like flooding, and stall out. The fuel pressure remains constant at 14 lbs PSI. Spark remains. After a few minutes it will start up and rev up to clear out and all is well till next ime.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What will cause a 1990 350 not to crank when it is getting fuel and fire and good fuses?
could be many things, probably a crank sensor
Where is the crank position sensor located on a ford 350 xl 5.8 liter?
The crank position sensor is located by the crank shaft on a ford 350 xl 5.8 liter.
Where is the crank shaft sensor located on a 1995 Pontiac trans am 350 motor?
Does your vehicle have the LT1? if so there is no crank sensor.. there is an optic sensor in the distributor that controls all..
Where is the anti knock sensor on a Chevy 350 block?
It is in front of the starter on my van.1990 350
1988 Chevrolet 1500 350 cranck shaft poitioner sensor?
Gm. did not use a crank shaft sensor in 1988, It had a distributor that done everything.
What kind of rear springs for 1990 Dodge Ram 350 van?
It has leaf springs.
Where is the Crank sensor location on a 1999 Tahoe 350?
It's on the bottom front of engine right behind the vibration dampener.
What is the sensor above the 350 engine oil pan and starter on your 1990 Chevy c1500 truck?
oil pressure switch or knock sensor
Where is the crankshaft position sensor located 1993 Chevy 350 5.7?
A 93 does not have a crank or cam sensor. Ask your question again. Tell us why you think it had a bad sensor, Tell us your symptons too.
Where is the crank sensor located on a 1989 caprice classic?
depending on what engine you have, 4.3 v-6 or 305 v-8 or if your lucky the 350......chevy never ran a crank sensor on an engine that old. If it wont start, check spark, if you have spark, check fuel.
Where is the crankshaft sensor located on a GM 5.7 350?
crawl under the engine, at the front where the crank pullet is you will see an elctrical connection right behond the pulley. New answer; Sorry but that is the cam sensor, The crank senor is behind the starter on the block, Depending on the year. Crank senor has never been inTHE FRONT OF THE ENGINE.
Can you use a 350 Crank and rods on a 350?
yes
