Want this question answered?
I don't think the bolt pattern is the same but you can buy an adapter that bolts to your intake that will accept the Edelbrock.
the edelbrock website should have that info.
DEPENDS ON WHAT TYPE OF INTAKE AND CARB. YOU'RE BEST BET IS TO GO TO EDLEBROCK.COM, ENTER THE CARBS MODEL NUMBER, AND GET A SPEC SHEET THAT THEY PROVIDE.
I have never seen a cast iron edelbrock intake so I would think not.
Or from autozone you can buy a quadra-jet to standard adapter plate if you don't have that edelbrock or if you have a holleythe intake manifold is hopefully what youre talking about and the answer is noAnsweryes you can. if you have a stock intake manifold, which uses a quadrajet carb, you can use edelbrock part number #2696 which you can buy from summit racing (www.summitracing.com). it allows you to use an edelbrock performer square bore carb on the stock quadrajet manifold. for that motor i recommend the edelbrock #1406 which you can also get from summit.
Probably not. Unless the previous intake and carb were not functioning properly.
With the mods you describe I would suggest you start at about 10 to 12 degrees btdc. you may have to play with it to get it just the way you like it. Hope this helps. Mike
274
Iron Intake to Iron Heads - 40ft lbs Aluminum Intake - 25ft lbs
without swaping heads or getting head work done your looking at approximatly 400 hp depending on the cam and intake and carb match.
25 ft./lbs.
weiand & edelbrock both make intake manifolds for the 87-95 350ci engines.