0
On a small block 305 with a edelbrock preformer intake and an edelbrock 600 cfm carb and headers with hei where should the timing be set how many degrees.?
Wiki User
∙ 16y ago
With the mods you describe I would suggest you start at about 10 to 12 degrees btdc. you may have to play with it to get it just the way you like it. Hope this helps.
Mike
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What should the timing be set at on 1986 Chevy 305 with edelbrock carburetor and intake with headers?
Try 12 degrees initial and see if it pings. If not, try a little more.
How much horsepower would a stock GMC 305 have if you put an edelbrock performer intake edelbrock carb headers and a summit cam with 282 int and 292 exh?
around 220hp i would say
How much more horsepower will headers and elderbrock intake help?
well you see the timematic conversion of the thirteenth neo is greater then the torque of edelbrock... so no
What would the estimated horsepower be on a 383 with cam headers pistons edelbrock intake and carb?
without swaping heads or getting head work done your looking at approximatly 400 hp depending on the cam and intake and carb match.
How much hp does my 350 have with 40 over flat top pistons vortec heads 1 point 6 roller rockers comp 268h cam headers and edelbrock intake?
375 sound right?
What is the torque specs on an edelbrock aluminum intake manifold for a 69' Chevelle 396?
the edelbrock website should have that info.
What is the torque for an edelbrock carburetor on edelbrock intake?
DEPENDS ON WHAT TYPE OF INTAKE AND CARB. YOU'RE BEST BET IS TO GO TO EDLEBROCK.COM, ENTER THE CARBS MODEL NUMBER, AND GET A SPEC SHEET THAT THEY PROVIDE.
Is the edelbrock torker manifold aluminumor cast iron?
I have never seen a cast iron edelbrock intake so I would think not.
What is the cheapest engine or way to make 400 plus HP in a 73 dart sport?
get yourself a 440 engine and drop it in your car, add headers to it and a good high flow exhaust and install a edelbrock air gap 4 bbl. intake manifold.
Do you add horsepower by installing an edelbrock intake manifold and carburetor?
Probably not. Unless the previous intake and carb were not functioning properly.
You have a gm 350 crate engine that had 260 hp you put an edelbrock airgap intake and a edelbrock 750 carb with a kn air filter how much horsepower will you have?
274
What is the torque specs on an Edelbrock aluminum intake manifold for a Pontiac 428?
Iron Intake to Iron Heads - 40ft lbs Aluminum Intake - 25ft lbs
