answersLogoWhite

0


Best Answer

Need to know what the symptoms are and any codes it has.

User Avatar

Wiki User

6y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Do I need to Replace 2003 Dodge Ram 1500 3.9L pcm?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

If i have a 2002 dodge ram 1500 with a 4.7 motor can i replace the 4.7 with a 2003 5.7 motor?

Not easily. You will need a different computer and wiring harness.


How do you replace a shifter knob on a 2002 Dodge Ram 1500 with standard transmission?

You need the user manual which has steps on how you can replace a shifter knob on a 2002 Dodge RAM 1500 with standard transmission.


Do you need to remove the serpentine belt to replace the thermostat in a 1998 dodge ram 1500?

no


Need a vacuum diagram for 2003 dodge 1500 4x4 where do I look?

The 4x4 system on a 2003 is not vacuum controlled.


How do you replace rear brakes 1999 dodge 1500?

i need a diagram on how rear brakes are assembled


What kind of antifreeze does a 2003 dodge ram 1500 need?

Red five year, hoat type


What size wrenches do you need to replace the starter on a 2000 dodge 1500 pickup?

5/8 in, 13mm


Door jam fuse 2003 Dodge Ram 1500?

my right passenger door to my 2003 dodge ram 1500 won't open or close. I have not opened it in over two years. Need help. I need directions on what to do, so I can buy part, put oil, or whatever I need to do. It is manual not electric.


When the transmission sensor is out on a 1998 Dodge Ram 1500 does it mean you need to replace the transmission or just the sensor?

All you need to do is replace the sensor. It cost around $20.


How much oil does a dodge ram 1500 4.7 need?

6 quarts of oil when you drain and replace the filter.


What rear axle assemblies are interchangeable for a 2003 dodge ram 1500 V6 3.7L 2wd?

2002 - 2005 Ram 1500 will bolt in, but you need to match the correct ratio.


How do you program extra keyless remotes for 2003 Dodge Ram 1500 when you have one remote that is already programmed?

You will need a scan tool to do that.