probably
on the gear box
If that is the only problem, then yes.
On the 1.1, it's screwed into the exhaust pipe near the engine, and has a plug/socket connection on top of the tyransmission. The Haynes manual shows it and tells you how to change it. Cost approx �63.00 from Motormania you must also buy a lambda 22mm 3/8 socket to get it of,you can not clean them either
This is a very common fault on these cars (i've had 5). Two of the most common causes of which are 1. A dirty idle control valve - Find, remove, clean and reinsert it. 2. broken Lambda sensor - replace original
Low on coolant or your sensor needs attention.
wheel brace is in the boot, left hand side as you look into the boot, fitted in a plastic clip by rear light cluster.
What's the question? Yes, a peugeot 106 has dashboard lights.
If it's anything like mine you should find it just underneath the windscreen wiper areaAnd if its anything like mine, pug 106 Zest XN, it doesn't have a MAP sensor. ;)
it is located on the inlet manifold below throttle body you need to remove manifold and remove sensor from underside
No the Peugeot 106 is not considered vintage. This is true because the Peugeot 106 was made in the year 1991. To be a vintage car you have to be around for more the 20 years
front of engine next to gear box i just looked and i cant see it is it underneath the engine ?
No