0
Not on most vehicles. You might have to pull the radiator on a big V-8, but it should not be necessary to pull the engine.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do you put a Cam in a 78' El Camino 350 engine?
You don't...
Can you put a single cam 3.4l engine into a 1996 Monte Carlo with a 3.4l dohc?
Yes
Is a split port engine a single overhead cam or a dual overhead cam?
Its a single cam.. it says " 2.0 Split Cam on the cover of the engine... A dual cam would say " 16V Zetec" on the engine cover.
What if motor not running because you had to put a cam in it?
I dont understand what you are asking. If the cam is bad the engine will still run just real bad.And running it with a bad cam could destroy the engine. Now if you mean put in a new cam,you will need new lifters and new valve springs with retainers and new valve stem seals. Also you have to "break in" a new cam, if you dont do it right it will fail within a few minutes. You need to be way more clear on what you are asking.
1990 gmc siera can you put a 1996 vortec 350 in it and if so is the cam in a vortec just a good as a RV cam?
You can put the Vortec in it if you have the wiring and ecm to run it. or you could use the Vortec heads and an aftermarket intake and really wake up your engine. The vortecs use a roller cam.
With 302 cam in to 351w engine works or no work?
this one i know thru experience,and a long time to figure it out. but yes a 302 cam will work in a 351.but, u will need to time the engine to 302 timing specs, not to 351 timing specs the same applies if you put 351 cam in a 302
Is there only one cam in a Chevy caprice 350 engine?
Yes there is only one cam in this engine
Honda accord 1996 2.2 vtec engine does this engine have a cam belt or cam chain?
Belt.
If my Mazda 323 has 16 valves is it a single cam or a twin cam?
Your engine is a twin cam.
After setting at TDC cam sensor shows 0 degrees until you put engine under a load then cam position changes from -20 to 30 degrees?
That is what its supose to do, Computor is advanceing the timing
Is the cam shaft in the differential?
no, the cam shaft is on the engine cylinder head..
Can a double overhead cam replace single cam ford engine?
No.
