answersLogoWhite

0


Best Answer

I changed out the blower fan on my 89 without having to remove any of the a.c. The fan housing is against the firewall in the engine compartment. There is a two-wire connector going to it and a small rubber hose for condensation drainage

User Avatar

Wiki User

8y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Do you have to remove air conditioning apparatus on a 1991 Pontiac Bonneville to install heater blower?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Install a transmission mount on 1989 Pontiac Bonneville?

i would rather not...


How do you install air door actuator in 2000 Pontiac Bonneville Where is this part located?

replace temperature door actuator.


How do you install the armrest on a 1993 Pontiac Bonneville?

I have a 1996 Bonneville and it has a Phillips head screw on each side of the armrest. If yours is like that then you should be able to just unscrew them and pop it out.


How to install heater core on 1996 Pontiac Bonneville?

You don`t want to go there !( Trust me.) Take it to a radiator shop.


How do you install a thermostat in a 1995 Pontiac Bonneville?

i just farted,how can i stop farting cause it smells like egg salad sometimes


How do you install a transmission in a 2000 Pontiac bonneville?

For such a large job, if it is not obvious to you, you should be using a repair manual, or take it to a competent shop.


How do you replace a headlight on a 1997 Bonneville?

Begin by removing the wiring harness from the back of your 1997 Pontiac Bonneville headlight. Remove the headlight assembly retaining bolts. Reverse the process to install your new headlight.


Replacing heater core on 1997 Pontiac Bonneville?

Begin by training the water from your 1997 Pontiac Bonneville cooling system. Remove the heater core water supply hoses. Remove the heater core retaining bolts. Reverse the process to install the new heater core.


Replace ignitio switch in a 1990 Pontiac Bonneville?

Begin by removing the retaining ring at the top of your 1990 Pontiac Bonneville ignition switch. The ignition switch will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install your new ignition switch.


Why 2000 Pontiac Bonneville want start with key but starts when - bypass?

See the answer to 2000 Bonneville Neutral Safety Switch Location. Had the same problem and that was my fix. You can install a separate Start Button in the Starter circuit to start the car also.


How do I install a water pump on a 1998 Pontiac Bonneville?

You have to remove the motor mount. Once the motor mount is removed you can remove the old water pump and install the new one. Make sure the area is clean before you install the new one.


How do you install 1998 Pontiac Bonneville taillights?

On the other side of the tail lights, inside the trunk fastened with plastic nobs, pull back trunk trim panel.