Chevy Blazer
Oldsmobile Eighty-Eight
Crankshaft Sensors
Chevy Blazer S-10

Do you know where the camshaft sensor is located on a 1991 Olds 98?

515253

Top Answer
User Avatar
Wiki User
2006-08-14 17:14:39
2006-08-14 17:14:39

The Camshaft and crankshaft sensors sit behind the main pully, you really need a mechanic to change this because if you don't torque it right they will shift and you will have to replace them again. The parts are only about $40 a piece but the labor will run you about 2-$300.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The camshaft sensor on the 99 Olds Intrigue is located on the engine block. It is under the starter, which has to be removed to locate the camshaft sensor.

User Avatar

On the 99 Olds Intrigue, the camshaft sensor is located on the rear of the engine. It is just above the starter.

User Avatar

its under the distributor cap its part of the distributor assembly

User Avatar

It is located on the distributor under the cap and rotor Crank sensor should be on the front bottom of engine by the crank pulley

User Avatar

The cam sensor is located below the water pump and left of center. Most likely if there is a problem with theis, then the magnet has come off of the timing gear (which triggers the sensor). Remove the senor, then use a mirror and turn the motor until you can see if it's still there. Good luck!

User Avatar

bad camshaft position sensor

User Avatar

i have a 2003 olds alero i need to know the location of the camshaft sensor

User Avatar

There isn't one on that engine. Only a crankshaft sensor at the back of the engine.

User Avatar

the crank sensor is behind the harmonic balancer

User Avatar

Where is the choke sensor on a 1991 Oldsmobile ciera 3.3L

User Avatar

I have a 98 olds intrigue...the camshaft position sensor is located around the middle polley on the left side of the engine. It has one screw. It's fairly easy to install.

User Avatar

The camshaft position sensor is right under the power steering pump. Remove the power steering pump to access the sensor.

User Avatar

The map sensor is located on the intake manifold on a 1996 Olds Achieva 2.4 liter. It is in the center of the intake manifold.

User Avatar

wHereis the abs wheel speed sensor located on 1998 Oldsmobile bravadaI

User Avatar

The knock sensor is located on the left side of the block. Often the steering shaft will contact and wrap the wiring harness around it, braking the connector. You should check this first, before replacing the sensor.

User Avatar

The temperature sensor on a 93 Olds Cutlass Cierra 3.3 is located on the back of the engine. It is on the intake manifold.

User Avatar

on front of engine below water pump pully

User Avatar

I believe it is on the right side of the engine near the throttle body. Look underneath the throttle body housing and there should be a sensor near the engine block. That would be your cam sensor. Hope this helps.

User Avatar

The ETC sensor on the 2002 Olds 3.5 engine is located at the right rear of engine, below the throttle body at the head not the block.

User Avatar

It is located behind the starter. You'll need to remove the starter to replace it.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.