how do you change a timing belt on a 1998 Plymouth breeze 2.0 liter engine
How do you change a timing belt on a 1999 Plymouth Breeze belt was broken?
Get a manual on your car from AUTOBOOKSONLINE.COM
You don't. This is one job that should be left to a professional.
how to change the reservoir of a power steering on breeze 1998
You have to remove the drive side tire and the wheel cover to get to the battery.
a lot of work. the transmission has to be removed.
About 5 for a filter change. 9 for dry fill.
You take off the left front wheel and housing. It isn't under the hood.
Remove the left front wheel and inside fender skirt. The rest becomes obvious.
The transmission would have to be removed, which is a really big job
Remove wheels Remove caliper mounting bolts Slide caliper off rotor rotor should slide off
Your water pump is damaged...have it replace its a big job you might want as well change your timing belt when you do it..
u ned to change and flush the colant system and replace the thermostat it gets gunked up i had to do it 2 times in a year........
The Fuel pump is located in the fuel tank. The tank must be removed and lowered to access the top of the tank. The fuel pump is located in the top area with the fuel sending unit. Not easy and must release the fuel pressure
yes, they are the same engine. however the neons changed the electrical connectors in 1997 so if your breeze is 97 or up then try to get a neon motor from 97 or up. if you cant, then you will have to change all the sensors.
undo bolts , take off old one put on new one replace bolts tourque to 106.
you have to take off the driver side tire and remove that black plastic covering that goes around the wheel well... you'll see it
How do i change out a water pump on a 1999 playmonth breeze/engine 2.4
Change the fuel pump. You have to remove the fuel tank and use a special tool to get the pump out.
To change the thermostat on a 1997 Plymouth Breeze 2.0, a bucket should be placed under the vehicle where the hose for the thermostat is. This will catch any leaking antifreeze. Remove the hose clamp from the top radiator hose where it connects to the engine. Note how the thermostat is positioned in the hose. Remove the old thermostat and replace with a new one. Tighten the hose clamp after reconnecting it to the motor. Check antifreeze level and refill if necessary.
How do I change th starter on a 1994 Plymouth sundance
First remove the tranny and flywheel. Then remove the old seal and put the new one in. Then put everything else back on.
I believ that a special tool is required it might be cheaper to have it done than to buy the tool
how do you change rear wheel bearing in 1994 Plymouth acclaim