0
Do you need to pull the 5.8 engine out of your 1993 xlt bronco to replace the rear main seal?
Wiki User
∙ 16y ago
no just the trans and transfercase and loosen the bolts on rear main bearing cap
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you change the rear main seal on a 1994 ford bronco?
Remove transmission and replace the rear main seal
1993 BMW 318i power window relay?
its like around $58 bucks. Not worth messing with. just replace it. I think its in the main fuse box in engine compartment
How do you replace a zafira thermostat?
The thermostat of a Vauxhall Zafira is located in front of the engine. The unit is on engine itself and has a main radiator hose connected to it. To replace it remove the hose and unbolt the house from the engine. Replace the thermostat in the housing.
Do you have to remove transmission to replace the rear main oil seal in a 2000 Chevy cavalier?
You must remove the transmission are engine to replace the rear main seal.
How do you replace the rear engine main seal in a 1999 Chevy Tracker 4 wheel drive?
Pull the engine.
Is it necessary to break down the engine to replace the rear main seal on the Toyota 5EFE 1.5 liter engine?
you have to separate engine and transmission
How do you replace a temperature sending unit on a 1998 Ford Contour?
Follow the main hose that goes from radiator to engine block. It is on engine block between the main hose connected to engine block and a pullye. The heat gauge wire is snapped on the sensor. Remove the wire and replace the sensor.
How do you replace a front oil seal on a 1988 Ford 2.9 v6 This engine is in a Bronco 2.?
The easiest way is to disconnect the motor from the mounts, and the transmission from it's mounts.use an engine hoist to lift the motor up about 4 inches and drop the oil pan. You will have to pull out the crank which means the bottom of the rods as well try not to move the pistons, you will have to replace not only the main seals, I would do both, but the oil pan gasket and the rod bearings.
Replace main bearings in a ford 302 v8 engine?
Best to do with the engine on a stand. The crank will have to be sent out if you want a clean job.
How much does it cost to replace a rear main seal in a GMC Yukon XL?
Oh, a lot; 4 figures. You have to completely break the engine down to replace a rear main seal.
Is 1996 ford bronco rear main oil seal one piece?
Yes this is a one piece for the 96 bronco
How do I replace the Rear main engine seal on a small block Chevy?
You will need to remove the transmission.
