counter clockwise to loosen.
It's on the bottom front of engine right behind the vibration dampener.
Right hand. Turn counterclockwise to loosen.
It is right hand thread. Turn counter clockwise to loosen.
After removing the right front tire and fender liner, you remove the serpentine belt. You then remove the crank bolt and use a puller to remove the pulley.After removing the right front tire and fender liner, you remove the serpentine belt. You then remove the crank bolt and use a puller to remove the pulley.
right above the dampener.
Right to tighten the ball and left to loosen the ball.
Adjustment is on the idler pulley with the tensioner bolt sitting right below the alternator. I also had to loosen the center bolt on the idler pulley before it would move.
You have spelled 'loosen' right. L-O-O-S-E-N.
Its the normal right handed thraed... It IS torqued to about 120 ft lbs though... You may need to wedge the flexplate/flywheel to keep from spinning the entire rotating assembly when you try to loosen it.
Counter clockwise to loosen.
to replace your fuel filter.you need to loosen off your gas tank and your filter is right on top of the tank do not replace this filter on a regular basis because it filters the fuel on the way out of the tank
left turn clyde.