0
Depending on the device, wrong wiring can result in a malfunction causing fire, electrocution, sever bodily injury, and possible death.
Viper1
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What colour wire goes to the breaker using 12-2 wire?
Black. wire goes to breaker, white wire goes to neutral bar, and copper wire goes to ground bar.
What are the common wiring in a receptacle?
Black wire is HOT, white wire is NEUTRAL and bare or green wire is GROUND. The black wire goes to brass colored screw, the white wire goes to silver colored screw and the bare wire goes to green screw that is connected to the metal "frame" of the receptacle.
How do you wire a light switch with only black and red wires?
Connect the black wire to the incoming hot wire and the red wire to the out going load.
Does it matter which black wire is connected to red?
There is not enough information to answer this question.
What electrical wire goes with the red and black in your ceiling?
There is not enough information to answer this question.
Does the red battery wire go on the right?
The red battery wire goes on the positive + battery terminal no matter which side it is on. The black wire goes on the negative - terminal.
Which wire goes to iat sensor on a Nissan Titan?
The wire that goes to the iat sensor is the red and black wire. the iat sensor is located on the air intake. The air intake is on the drivers side. There are five wires that are on the drivers side.
Does the red wire go on the plus sign on a battery or the minus?
The red wire is Positive, (+) and the Black wire is Negative. (-)
What colour wire goes to the breaker using 12-2 wire?
Black. wire goes to breaker, white wire goes to neutral bar, and copper wire goes to ground bar.
Is Black wire vs black wire with white stripe positive or negative?
Any marking (a white stripe, bump molded into the cable, different wire colours) is an indication for your reference only. It doesn't matter, as long as you connect the marked side on the amplifier to the same polarity on the speaker side.
Which wire goes on the gold screw the white or black?
In typical American wiring the black wire on an outlet goes to the gold (copper) screw and the white wire goes to the silver screw. The ground wire goes to the green screw.
When you are replacing a male plug on an electric cord. Which screw does the black wire go on?
The black wire goes to the brass colored screw and the white wire goes to the silver screw.
How do you wire the alternator on a 1968 Ford Mustang?
Hello. If your car has a charge indicator light, you should have a white wire with a black stripe hooked to the stator post, a white wire to the fld post, a black wire with a yellow stripe hooked to the bat post, and a black wire with a red stripe hooked to the ground post. The white wire on the fld post goes to the F terminal on the voltage regulator, the white wire with black stripe on the stator terminal goes over to the S post on the voltage regulator, the black wire with the yellow stripe on the bat post goes to the hot side of the starter solenoid, and the black wire on the grd post goes over to one of the attaching screws on the voltage regulator and also to the passenger side of the engine block, where it is attached with the same bolt that holds the negative battery cable to the block. If your car has the charge indicator gauge instead of the light, the stator post is not used.
How do you wire a wall plug socket?
Wall receptacles are wired in parallel. black to black, white to white, ground to ground.
How do you install a sunpro super tach 2 in a 95 4 cylinder s10?
red wire goes to positive battery white and black wires are for the light white wire being the positve and the green wire goes to the ignition control modtral on passenger side motor on the coil packs it goes to the white wire
What are the common wiring in a receptacle?
Black wire is HOT, white wire is NEUTRAL and bare or green wire is GROUND. The black wire goes to brass colored screw, the white wire goes to silver colored screw and the bare wire goes to green screw that is connected to the metal "frame" of the receptacle.
What side of a car battery do you hook the power cord up too when setting up an amp?
RED wire goes on +, and the black wire gets wired to the body of the car. Which is ground -
