No, it uses a timing chain. The long belt that you see under the hood is a serpentine belt. Replace if excessively cracked or worn. The other smaller belt off to the right, when looking at the engine, is the Power Steering belt.
Hope this clears things up for you.
picture of engine of 1991 ford aerostar van
( there are 6 engine cylinders ) for the 1994 Ford Aerostar 3.0 liter V6 engine
You have a blown head gasket or a cracked head. STOP driving this car immediately or you will do serious damage to the engine. It will need the gasket replaced and the head checked.You have a blown head gasket or a cracked head. STOP driving this car immediately or you will do serious damage to the engine. It will need the gasket replaced and the head checked.
Does it quit shaking when it warms up? What engine and year of Aerostar?
On a 1993 Ford Aerostar , 3.0L V6 engine : The distributor is located on the TOP of the engine , near the REAR
Have the fan motor checked to see if it's getting power. If not,then it will need to be replaced.
In a 1990 Ford Aerostar : You either have the 3.0 liter V6 engine or the 4.0 liter V6 engine from the factory ( each size of engine has 6 engine cylinders )
It appears that the Ford Aerostar with 3.0 engine does not have a crank position sensor, but the 4.0 engine does have one.
A 1995 Ford Aerostar either has a 3.0 liter or a 4.0 liter V6 engine ( The 3.0L has the engine oil filter on the drivers side of the engine and the 4.0L it is on the passenger side of the engine )
On a 1997 Ford Aerostar : On the 4.0 liter V6 engine the oil filter is on the passenger side of the engine On the 3.0 liter " Vulcan " V6 engine , it's on the drivers side of the engine
in the engine compartment you have relays at lease on my 1993 i have 4 the no. 4 relay if removed car wont start try this. I have a 1990 aerostar 3.0, I shut it off and at the store, then wouldn't start, and I replaced the module on the side of the distributer and it fixed the problem.
If it is clean, undamaged, and in good working condition.....NO. Since the radiator needs to be removed, to remove the engine, now is a good time to have it cleaned and checked.
Bank 1 is the passenger side of your engine in a 1996 Ford Aerostar
Whats wrong when an 86 ford aerostar keeps trying to start after the engine is running?
Could be a problem with the wiring from the computer to the sensor.
where can i find a vaccum line diagram for a 1992 ford aerostar with a 3.0 engine
On a Ford Aerostar 3.0 ( and 4.0 ) 3 - 6 2 - 5 1 - 4 front of Ford Aerostar
The symbol is for the cathalitic converter (petrol engines) or for the particulate filter (diesel engine), they have to be checked or replaced. Generally, this symbol means the depolution device, in any car.
Is there a reset button on a 1996 rav4? Had it checked out, and said it need spark plugs and wires. Replaced it and check engine light still on.
A 1993 Ford Aerostar would have come from the factory with ( 5W-30 )
= "Do you have to flash the computer after you replaced the engine?" =
On the rear of the engine on the passenger side
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.