YES! It can only be installed properly in one position. If you turn it then it should have a slot that it fits in.
no sgc signal. cam position sensor
The rotor thickness for your 1997 Pontiac Bonneville is 0.75. When the rotor falls below this thickness a certified mechanic can no longer use the rotor.
That would be the pick up plate in the distributor under the rotor and cap.
That is the only electrical device that is in the distributor. Remove the distributor cap and rotor and you will see it.
The Mazda Familia is also known as the Mazda 323. A 1997 Mazda Familia is recommended to use 10 W 30 oil.
where do you add clutch fluid on a Mazda 1997
will a 1997 Mazda 626 transmission or engine interchange with a 1999-2002 Mazda 626 transmission or engine
Trouble code P1744 means: TCC system mechanically stuck in off position
how many oxygen sensors are on a 1997 Mazda mpv lx
In order to get the set screw in a position so it can be easily removed, you have to get the rotor to rotate. Act as if you are going to start the car, but only hold the key in the start position for a split second. The cars engin will turn over, and the rotor will rotate, hopefully to where it is easier to get the screw out. If not, try again.
Need to know how to fix the horn on a 1997 mazda millenia that doesn't work?
Cap and rotor, yes. Points, no.
What Mazda is it? I can find out for you.
Answerthe camshaft sensor is the distributor but the crankshaft position sensor is located right next to the crankshaft its held on by one bolt
you take it out
There are a few locations where one can find a fuse box diagram for a 1997 Mazda. These diagrams can be obtained through Mazda and locations such as Auto Fuse Box Diagram.
It is inside the distributor, under the cap and rotor.It is inside the distributor, under the cap and rotor.
Under the bonnet
distributor or coil
How do I re-program a remote for a 1997 mazda millinea?
1997 Mazda MPV's SUCK A**! Do your self a favor and save yourself a lot of headaches and get rid of the turd!
The 3.8 liter V6 engine has a distributor cap and rotor in a 1997 Ford Thunderbird
You can adjust the camshaft on your 1997 Mazda 626 with the camshaft adjustment bolts. You can access the camshaft adjustment bolts by removing the cylinder heads.
The 1997 Mazda 626 starter is located near the back of the engine at the bottom. You can follow the positive battery cable from the battery to the starter.
1997 Mazda 626 2.0L MFI DOHC 4cylThe Spark Plug Gap.044 (In thousandths of an inch)