answersLogoWhite

0


Best Answer

Have you checked the fuse for the ECU? I'm unfamiliar with your specific vehicle, but this fuse is ussually located under the hood in a fuse box. Normally the manual will help you track down the location of all the fuses. If its not the fuse, perhaps there is a ground somewhere. Be sure there is not another fuse that may have blown when you fried the ECU.

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Fryed ECU in 1992 4Cyl TR Mitsubishi Magna when changing down gear. Changed ECU for a good one but the engine only turns over now and will not start. Checked everything but still cant find problem.?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

No leaks and thermostat changed 1992 Mitsubishi Eclipse still overheats whats next?

There are several things that can cause your 1992 Mitsubishi Eclipse to overheat. A malfunctioning water pump or a blown head gasket should be the next things that are checked.


1987 Kawasaki 454 Ltd wont turn over after changing handlebars checked the wire and changed the battery?

the motor is probably seased......


How do you reset a sunroof for a Mitsubishi endeavor?

you go to the dealer and get it checked out. they have to do it for you.


Why might a Mitsubishi Diamante be misfiring?

Go somewhere and have your timing checked.


You bought new tiresbefore changing tires you did not need an alignment Do the new tires need a front end alignment?

I'd at least have it checked, just to be sure everything's fine


What could be wrong with turn signal if everything has been checked and they still dont workwhen i say everything i checked fuzes..bulbs..relay was changed under dash my four ways and breaks work?

Only thing left is two things: 1. Turn signal switch 2. Wiring between switch and fuses.


Backup lights do not come on. 88 GMC 1500 truck?

could be a bunch of little things....I had the same problem....changed the bulbs...nothing...changed the tailight circuit boards....nothing...checked the fuse...good.....changed the nuetral saftey switch on the colum....nothing....the only other thing it could be is a bad wire from the fuse to the light or a bad ground.....its up to you... 1st thing id do is check the wires ground and fuse....then go about changing everything else.


If your monitor colors are very dark and adjusting controls or changing monitors and video cards has not helped how do you adjust the colors?

All COMPONANTS have been checked and or changed. It has to be in the motherboard, possibly an issue with the PCI/ISA slot.


Why is the engine on a 2001 Mitsubishi galant vibrating so much?

Have your motor mounts and transmission mount checked.


How to change camera lens?

Instead changing lens, which is not an usual procedure, it would be advantageous to purchase a new camera that has the kind of lens you are looking for. Normally, lens is a part of the camera that can't be changed, except on expensive models. In this case, changing the lens is an easy procedure that can be checked on the user manual.


How much will it cost to fix a cylinder misfire on a 97 Mitsubishi Mirage?

Have you checked the spark plug wire for that cylinder,??????????


Mitsubishi mirage car turns off when coming to a stop?

i have a 97 mirage 1.5 that did the same, have your alternator and battery checked.