It could be that or in the switch. But probable it is the actuator on trans mission..
Answerchange your 4x4 actuator It could be that or in the switch. But probable it is the actuator on trans mission..
press the oil button then press the reset button hold for five seconds it will reset oil life monitor back to 100%
If you turn the ignition to the on position, and then press the interlock button, you don't have to press the clutch pedal down to start the truck.
Turn radio on press the "set" button once press the "sel" bottom once using the tuning/seek button and pressing either up or down to move the "hour" press the "sel" button one more time use seek button to set "minute" wait about 2 minutes and it will go back to radio controls
have you tried turning off the radio and then press the set button then press the scan (up, dn) for hours then seek (up,dn) for minutes then press set again
turn power on to radio,press and hold sel till clock shows then while still pressing the sel button press at the same time the set button,"p will show"press sel again and the radio will walk you through the process
With the ignition on, press and release the "set" button on the radio. Within 5 seconds, push the "Scan" button to set the hour, push seek to set the minutes.
With the radio turned off, you press the SET key, then using the Volume and Tune buttons, you set the time. Once set, press the set button, and your done.
On the column, below the ignition switch, round button, press in the centre to activate, pull out on outside collar to shut off.
If you are unable to press in the button to move the shifter. Replaces the brake switch connected to the brake pedal.
Turn the ignion on, turn radio off. Press the "Set" button. Use the "seek" and "scan" buttons to set the time.
I own a 1992 Aerostar. I believe you will find a reset switch button behind the covering under the dash on the passenger side of the front. You should be able to gently pull the cover back away and reach in, locate the switch and press the reset button.