Assume you mean the seal on the rack and pinion steering??? If that part is leaking Power Steering fluid, it's because there is an internal, high pressure leak. That type of leak is usually caused by a worn bushing. Once a rack and pinion assembly starts leaking, the only option is to replace it since most people and most shops do not have access to the specialize equipment neessary to rebuild the assembly. It is highly recommended that the assembly be replaced before it wears to the point that metal shavings get into the power steering pump. Once that occurs, you'll need to replace the pump and hoses as well.
A 1995 Ford Thunderbird is OBD I , EEC IV
Where are the vacuum hoses on a 1995 ford thunderbird 4.6l engine?
To change the voltage regulator on a 1995 Ford Thunderbird, first you will need to disconnect the battery cables. Then, remove the bolts holding the regulator to the frame of the vehicle and the wires connecting it.
For a 1995 Ford Thunderbird , 4.6 : I believe that is rated at ( 205 horsepower from the factory )
A 1995 Ford Thunderbird , 4.6 liter V8 engine has ( 1 ) timing CHAIN to each cylinder head ( 2 timing CHAINS in total )
how much hp does 1995 ford thunderbird have
in the trunk
For a 1995 Ford Thunderbird : ( " regular " unleaded gasoline , 87 octane )
how to cahange front pinion seal
no....the answer is no. sure you can all the 95s have the same trans would be a direct swap