Open the hood of the engine compartment. Locate the light bulb connector on the back of the headlight. Take hold of the light bulb connector, push in and turn at the same time. The light bulb will come out.
Where is the headlight relay for a 1991 mercury Capri
The 1991 Mercury Sable ignition switch is held in place with a retaining ring. Loosen the retaining ring. Pull the ignition switch out. Remove the wiring harness from the rear of the ignition switch. Reverse the process to install the new ignition switch.
They unscrew from the back of the light assy. You may have to remove the light to get ot it.
go ask ur grandmother
You remove grill to remove and replace the headlights.
You may have compression on any cylinder where the valves happen to be closed, but you will not have compression on all cylinders. 1991 Sable does not have a 305 engine.
You have to remove the entire headlight assembly. Glass cover clips on with plastic clips. Remove and install CAREFULLY as glass breaks easily.
With great difficulty. Raise the light, remove the black plastic trim piece, remove the headlight bezel then remove and unplug the headlight. The housing/motor assy is held in by four screws but the lower two are blocked by either the windshield washer or colling water reservoir bottle (depending on side). The difficult part is that the car is build like a Chinese puzzle and you might have to remove a bunch of other stuff off to get the coolant reservoir off (I haven't actually done the other side and I hope not to). Good luck
located at the rear of the headlight is a manual raise/lower knob. turning this knob in either direction will raise/lower your headlight.
unplug the bulb, then remove the metal clips on front of headlight that secure it to the grill. pull the headlight straight out of the front of the grill. This is the best way to change the bulb as well.
The fuse block should be located to the left of the steering column, under the dash. Depending on which Mercury GS you have (sable, topaz, etc.) it should be a relay located in the fuse block.
Its held in with 4 star shaped screws... just disconnect the headlight bulbs, remove the screws and install the same way that you took that out with.