Not 100% sure on the passenger side, But on the drivers side you simply take a flat (common) screwdriver and gently pry up the front and back ends of the black switch base. There are two clips that keep the switch base in place, if enough upward pressure is applied the whole base sould come right up. Then you can access all of the wires underneath.
The passenger window on a windstar is best installed by a professional. However, if you have some auto repair experience, you can easily remove the door panel on the door by removing the screws and then you will be able to install the new window.
2001, 02, 03 Ford Windstar passenger power window switch.
Remove the decorative cover to the window switch panel. Remove the window switch retaining screws. Remove the wiring harness from the back of the window switch. Reverse the process to install the new window switch.
what the number of the fuse on window 95 windstar diver side
On most cars it just pries out of the door handle. Be careful not to break it.
The switch could be bad at the passenger seat. The switch could be bad at the passenger seat.
Defective passenger power window switch. It is stuck in the down position. Raise the window and immediately disconnect the switch until you can replace it.Defective passenger power window switch. It is stuck in the down position. Raise the window and immediately disconnect the switch until you can replace it.
I wouls suspect the passenger side switch is defective. Salvage yard is a good source for this part.
with a mallet
electric window binds on 2003 ford windstar
For my '01, I removed the associated cover/panel using a Torx T47 bit (to remove the seatbelt bracket) and a Phillips screwdriver. Disconnect the electrical plug ans, using an 8mm socket, remove the motor for the body. The swivel arm has a spring clip that disconnects the motor from the window. I had the same problem in a '96 with both windows. The problem was the switch, you can open and clean the contacts with sand paper or replacing the switch.
if the glass is the only problem you will have to drill out the rivets in the glass or remove the bolts if someone has done it already