I had stuck rear rotors on my 03 RAM HEMI 1500 and was able to remove them by doing the following. Spray penetating oil in any wheel stud cracks, center hub, and behind the rotor where it meets the hub. Use the new rotors for reference.
Next, put a small 6mm or 7mm socket in the big caliper braket bolt holes. Put the caliper braket back in its stock location and screw in the caliper braket bolts, pushing the 6mm or 7mm socket's against the rotor using the guide holes which the caliper bracket bolts pass through. Torque all the way down both bolts.
Next, use a C-Clamp from the rotor to the center hub in the front. Tighten as much as you can without breaking.
Next, try to drive a screw driver into the back of the rotor where it meets the hub if there is a small gap.
Next, douse in pepnetrating oil in the places mentioned above. Wait 5 minutes.
Lastly, use a small sledge hammer to bang out the rotor. When installing new rotors, use a small amount of anti seize on the inside area of the rotors.
remove wheelremove brake caliperremove rotor
replace front brake rotors and pads.
dodge 2001 Dakota brake lights won't burn Check the fuses. If the fuses are okay check the brake light switch.
You will need to remove the tire and wheel from your 2005 Dodge Durango. Remove the brake pad Springs and calipers. Tap the rotors with a hammer to loosen them. Slide the rotors off. Reverse the process to install the new rotors and brake pads.
In my 1989 Dodge Dakota the brake light is on fuse number13 it is a 5amp it also goes to buzzer, speed control, check engine light, anti-lock warning light, and other things page 12-19 Haynes 1987- 1993 Dodge Dakota Repair Manual
With a mechanic!
The 2001 Dodge Dakota, with a towing package, has a trailer brake built in. The trailer brake is part of the towing package.
take it to a qualified dodge mechanic
depending on the material you can machine them true again
Replace the pads, and the rotors. You need to change the brake pads and the rotors.
.374
Warped brake rotors.