Carefully insert a thin flat (smooth) blade between the vertical center of the license lamp lip (facing you) and the bumper cover. Carefully pry to raise the lamp frame/lip away from the bumper cover. Grasp the edge and pull outward and toward you to remove the lamp assembly. Twist the bulb socket counter clockwise and pull it out of the lamp assy. Pull the bulb straight out and replace with new. Replace the lamp assy by positioning it exactly as was as you pulled it out, then merely push/snap it back.
fog light not working and radio light went out
Refer to owner's manual for pictures of how to do it but basically you just pry it off and then twist and pull light bulb off
how to change a brake light on 2002 Nissan altima
Nissan altima 2001 hesiates at stop light?
http://www.paulstravelpictures.com/Nissan-Altima-Rear-Brake-Light-Bulb-Replacement-Guide/Nissan-Altima-Tail-Light-Bulb-Replacement-Guide-011.html here you can see every step to that question.. I just did it.. and works :) by Paulo Fernando!!
how do you reset the oil light on a 2000 altima
where do i find the srs fuse for a 2001 Nissan altima
how do you replace shift gear light on a 1998 le altima car?
What should you do when the enigne light comes on in the nissan altima 1996 and how should i go about fixing what does it need?
The tail light fuse controls the headlights in a Nissan Altima. A second fuse box is located next to the battery.
you must pull out the entire breather assembly, then you unscrew the housing. Next, flip the retaining clip and replace the radiator.
how to change the rear tail light bulb on a 2004 Nissan maxima
how do you change the passenger tail light of a 1997 Nissan altima gxe
low brake fluid
How do you replace dashboard light on 2000 Nissan almera
How to replace a brake light on a nissan Tiida hatch back.
brake light and battery light is on
H1 size Bulbs
looking for the same thing
put the key in the shifter
smash it in wi a hammer
You justs need to pull it out,, there is no screews to remove or something like that,, there are just press-aseembly parts,, pull it out with a screewriver or something like that,, just take care of the paint around the light,, Bye!! Jesus S..
Probably the wrong voltage