In most cases they leak hydraulic oil out the back of the cylinder. Crawel up and under the drivers side clutch pedal area and look for fluid leaking inside where the clutch actuator rod enters the back of the clutch master cylinder. It should be dry.
Vac leak, and paddle goes down to the floor.
Look for leaking fluid at the slave or master cylinder.
The gasket to your clutch master cylinder is probably broken or cracked. or your master cylinder is bad.
They sometimes leak hydraulic fluid down on to the carpet where the peddles are.
There is no adjustment on that year. You either have a worn out clutch disc or a bad clutch slave cylinder. Could be a bad clutch master cylinder too.
First you need to find out if your slave cylinder is leaking clutch fliud.check lines to slave cylinder from master clutch cylinder if no leaks most likely master clutch cylinder bad.
After you have located the clutch slave cylinder, have someone depress the clutch pedal. You should see the piston of the slave cylinder extend somewhat. If it does not, either the slave cylinder is bad, or the master cylinder, or, there is not enough brake fluid in the system for it to operate properly. Check the level in the master cylinder. If the slave cylinder is leaking profusely, it is probably bad.
Does my 1995 Toyota Paseo have a clutch cable
Hydraulic clutch? Maybe a bad rear seal in the clutch master cylinder
It is notadjustable, You either have a bad clutch slave cylinder, clutch master cylinder. The clutch and pressure plate may just be worn out.
It may be that your clutch master cylinder is bad, or more than likely one of the internal components within the cylinder, have the clutch master cylinder checked.
bad slave or master cylinder
No.... There is not an adjustment what so ever. You either have a bad clutch slave cylinder / clutch master cylinder. Are the clutch and pressure plate are worn out.