0
How difficult is it to replace a driver's side front fender on a 1996 Olds Achieva and does it require any cutting or welding?
Wiki User
∙ 14y ago
the front fender is really easy to replace. you first have to remove the two bolts holding the hood to the car, they will be on the body when you lift the hood up. you will then need to take the two or three screws out that you will find where the hood sits. after that remove the screws that hold it to the wheel well theres usually 4-6 screws. after those are out its pop and pull
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Which Olds replace the Achieva?
Alero
How do you replace a heater core in a 1998 Oldsmobile achieva?
how do you get to it
How do you replace thermostat on 1996 achieva sl?
Below-
Fixing broken thermostat housing for 98 lods achieva?
replace it
How do you replace the radiator on a 94 Oldsmobile acheiva s?
How do you replace an 1994 3.1 Oldsmobile Achieva s radiator?
How do you replace the water pump on a 1995 Oldsmobile Achieva?
is it hard to change the water pump on a 1992 Oldsmobile achieva. Yes, it is very hard to replace a water pump on an Achieva. When the pump died on my 1996 Achieva, the engine needed to be unbolted and removed to get to it. As I recall, it cost about $500. I have a 95 Olds Achieva 3.1 and the water pump was very easy to change. Mine is on the front passenger side of the engine. Very easy to get to, just be careful not to break any bolts off. lol
How to replace heater core in a 1996 olds achieva sl?
To replace most heater cores you have to remove the dash on the passenger side.
How do you replace a serpentine belt on an 97 Olds Achieva?
replacing achieva serpentine on a 96i have a 96 and you have to completely remove the motor mount and all of the bolts holding it on the engine to replace the belt,also carefully jack up the engine since it will fall on the ground if you take off the mount
Why does your heater occasionally stop working and there is water on the floorboards on a 95 olds achieva?
you need to replace your heater core.
How to locate and replace crankshaft sensor on 1996 Oldsmobile Achieva 2.4 liter engine?
did u ever figure it out?
Where is the fuel filter located on a 1995 Oldsmobile Achieva?
Back by the fuel tank itself, look around and it is easy to get and replace
Where is the crank position sensor located on a 97 Pontiac Grand Prix SE 3.8L V6 and how difficult and expensive is it to replace?
It is located on the drivers side of the crankshaft pulley. The shop time to replace it is 1.4 hours and the part is about $80. It would be around $225 to have the dealer replace it.
