Buy a new part and mount it to the firewall by the egr valve and connect the wires and vacumm lines and leave old one on block.
You mean, I think, ignition switch module, which is the location of the ignition switch.
Yes, a modulator is required if you use a RF cable to connect it to the TV.
it is on the firewall and difficult but not impossible to get to and replace.
How do I replace the windshield wiper switch?
You do not need a key to replace the ignition switch.
How do you replace the hazard switch
most likely the modulator on the tranny not shure of the spesifics on a 89 but its a cheap part (it will have a vacuum line going to both ends of it ) if you take the modulator out and there is fluid in there you need a new one if the diaphragm is torn you need a new one but for the hell of it since your gonna have it out you sould replace it anyway cause its a cheap part that will eventually need replacing
you dont HAVE to remove it but it does make it easier. removing the column it not very difficult.
its under dash on left side of steering column theres a rod that runs from your blinker switch when you pull on it that pushes down this switch on your column It may be difficult to remove without lowering column. I unplugged old switch, on '89, pluggged in new switch, set new switch on dim, and wired switch to column so now only have dim lights but avoided paying a lot to a garage to replace switch.
Either there is a bad electric switch or the computer is at fault.
Thermal transistor is an efficient heat control device which can act as a heat switch as well as a heat modulator.
replacing the volume control switch on 2008 flhx how to replace the volume control switch on 2008 flhx