0
How do I fix a 2003 grand prix ignition that will not return to original start position when you turn the car off?
Wiki User
∙ 13y ago
Push on the gear shift putting pressure forward or wiggle it as you turn the key.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How do you install the ignition switch in a 2004 Pontiac grand am?
The ignition switch in a 2004 Pontiac grand am can be installed by first Sliding out old lock cylinder and then Press the small release tab While turning the key to the ON Position.
1993 Grand Am engine cranks but does not start No spark No power to instrument panel gauges when key is in the on position?
ignition starter switch
How to replace crankshaft position sensor on a 1983 mercury grand marquis 302 v8 engine?
1983 doesnt have a crankshaft position sensor. you have an ignition module located on the side of the distributor.
How do you program a keyless transmitter for a 1993 Jeep Grand Cherokee Laredo?
This works for the 1993 Grand Cherokee: Sit inside the vehicle with all the doors closed. Place ignition in the OFF position. Open the driver's door. Leave Open. Move the mechanical door lever to the LOCK position. Turn the ignition to the RUN position. Aim the transmitter at the Keyless Entry receiver and press Lock button. Hold for five seconds until the door locks cycle. Turn ignition OFF within 20 seconds.
How much to fix a ignition on a Pontiac grand am 1999?
how much to insall a ignition to a pontiac grand am se 1999?
Why would the ignition switch in a 1995 Pontiac Grand Prix sometimes lock up in the run or unlock position?
Your ignition lock mechanism is worn/damaged (How much junk do you have on that key ring, Bub?). It needs to be replaced.
Why won't the keys in the ignition turn on a 1992 grand marquis?
Why won't the keys in the ignition turn on a 1992 grand marquis?
Have a 95 grand am SE car starts then immediately shuts down what could be the problem?
If the problem is not some where in your fuel line, then it is the Ignition switch. The ignition switch may not return from the start to the run position or the accessories may not work because the screws that hold the switch in place were overtightened. Often found in the 1992-94 models. I have not yet heard of this problem on the 95 model though.
Your grand am ignition wont turn off?
change ignition switch and/or tumbler
Is the door and the ignition key the same for a 97 Jeep Grand Cherokee?
I have a 1997 Grand Cherokee, and my key fits both the door and the ignition.
Where is the ignition relay on a 1990 Grand Am?
It has no relay.
Does a 91 grand am have an ignition coil?
Yes
