How do alternator mounting bolts look on the 2001 Pontiac grand am?
On your alternator, there should be two bolts on either side of the alternator. Losen the surentine belt up enoungh to slide off the pully of the alternator. Remove the two bolts on both sides of the alternator and slide the alternator up.
Remove Air Cleaner Box Assembly to gain access to alternator, Loosen bolts on alternator mounting bracket to relax alternator, Push alternator towards block to relax belt and away from block to tighten. Now tighten alternator bolts while keeping tension on alternator.
Book Says: 1 Detach the cable from the negative terminal of the battery. If vehicle is equipped with Delco audio system make sure you have activation code prior to disconnect. 2 Clearly label then unplug and unbolt the electrical connectors from the alternator. 3 Remove drivebelt. 4. Remove alternator mounting bolts and the alternator. 5 Installation is reverse of removal.
alternator on a 2000 Pontiac runs off a serpentine belt if its loose then chances are ur serpentine belt is worn or stretched or your tensioner pulley is bad or the tensioner itself..alternator bolts stable does not move like the old setup.
To replace the thermostat on a 1997 Pontiac Grand Am 3.1, first disconnect the negative battery terminal and loosen the clamp on the radiator hose. Next, remove the mounting bolts from the thermostat housing and insert the new thermostat.
Disconnect negative battery cable first. Locate alternator. locate belt tensioner. Use rachet to retract belt tensioner so belt can be removed off alternator. Remove alternator mounting bolts. disconnect positive cable and field wires from alternator. Remove alternator. Reverse to install. Removal of negative battery cable first prevents a short should the wrench touch metal or car ground. Some mechanics just remove the positive cable but risk a dead short shoud the wrench touch vehicle ground.
The catalytic converter on a 2004 Pontiac Grand Prix is located under the vehicle. To remove it the bolts which connect it to the exhaust manifold must be removed. The bolts which connect it to the other piping will need removal as well. After all mounting hardware is off the converter will come off.
i had Pontiac 1994. Toremove two inner bolts i took radiator vent. To access outer bolt i took out a battery, air filter completed with a part of air intake.And i used mirror
Take it to Mechanic!
Front caliper bracket to knuckle, 85 ft lbs. I also use a drop of blue "Loctite" thread locker on clean threads.
Remove the wiring harness from your 1992 Plymouth Grand Voyager alternator. Remove the alternator belt. Remove the alternator retaining bolts. Reverse the process to install your new alternator.
There is none on GM cars
3.3L and 3.8L Engines The 3.3L and 3.8L engines were equipped with the Nippondenso alternators. 1. Disconnect the negative battery cable. 2. Remove the alternator drive belt, by relieving the tension on the dynamic tensioner. 3. Loosen the nut on the support bracket at the exhaust manifold, do not remove it. 4. Remove the alternator tensioner/power steering bracket bolt. 5. Remove the tensioner stud nut and remove the tensioner. 6. Remove the alternator mounting bolts… Read More
The mounting bolts that attach the compressor to the engine.
usually in alternator
with a wrench.
How do you maneuver and remove the alternator from a 1998 Plymouth Grand Voyager with at 3.3L engine if you have already disconnected it?
You have to remove the wiper cowl assembly, and the alternator mounting brackets.
Disconnect the negative battery cable. Remove the windshield wiper module for. Remove the accessory drive belt. You will also need to remove the lower bolt and wiring harness from the oil dipstick tube. Take the mounting bolts off of the alternator and disconnect the alternator's electrical harness. This will allow you to remove the alternator assembly. Install the new alternator and connect the electrical harness. Tighten the mounting bolts and install the drive belt. You… Read More
The 1995 Pontiac Grand Am center console is held in place with for retaining bolts. Remove the shifter knob. Remove the center console retaining bolts. The center console will come off.
I actually was suprised my grand prix was squealing and it was the alternator. I got it replaced and it has stopped.
Its on the top front of the engine. Closest to the windshield and firewall.
Alternator is not putting out a charge.
138 inch pounds
Bell housing bolts and the torque converter bolts.
Where is the power steering reservoir on a 2000 Pontiac grand prix gt and is there an easy way to access it?
The power steering resevoir on a 2000 Pontiac Grand Prix Gt is located below the alternator. It is between the alternator and the fire-wall, and just below the two heater hoses..
hey!look at the engine.the alternator is located on the passenger side of the engine.you should see the copper wires through the holes of the alternator.
It isn't easy! I just did the alternator on my 94 Grand Caravan 3.8 L. Book instructions don't help all that much. FROM underneath the van: Disconnect the negative terminal from the battery. If you can remove the exhaust pipe from the exhaust manifold, it's easiest to take it out from underneath. There is a support brace that goes from the Power steering pump bracket to the engine block. Remove it, then remove the upper… Read More
Alternator fails to supply power.
77 foot pounds
How many connections should a alternator have on a 96 Pontiac grand prix
Remove the belt from your 2001 Suzuki alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.
There is no ground wire.... it grounds through where it touches the engine
you should have an motor mount on the passenger side of your car you need to jack the motor up on the oil pan and pull that mount of there should be six bolts to on the top and 4 on the connector plate that connects your motor to the car pull those and that pieces should fall down the you will need to take the belt of the alternator and the remove the bols… Read More
2002 Pontiac Grand Am has a lot of standard features and a five speed manual transmission available. It has a 105 amp alternator and fuel tank of 14.3 gal.
18 ft pounds
There are bolts surrounding the headlamp. remove these and the wires.
Remove wheel Loosen flexible brake line Remove mounting bolts (2) usually either TORX or ALLEN Slide out Remove and Plug brake line Be sure to use NEW copper gaskets upon installation
Why would a new alternator get very hot within one minute of being installed on a 1999 Pontiac grand am?
91 Honda accord the alternator is getting hot
Typically, a bad or "going bad" alternator.
the alternator is on top of the engine start by takin off the fan belt and then removing the wires conected to the alternator finally unbold the bolts holding it on and then take it off
Remove battery connections, then slacken the serpentine belt. Removal of alternator is simple and straightforward, 3 bolts, replace in reverse order.
There are bolts surrounding the headlamp. remove these and the wires.
195 fp n 205 for gt
caliper bolts are the two bolts that hold a brake caliper to the caliper mounting bracket. On both the front and rear of the vehicle (unless has rear drum brakes) the bolts have rubber boots around them working as slide pins.
The crankshaft sensor is on the side of the engine behind the alternator. It is mounted close to the oil filter,
Remove the wheel and caliper. Then rake off the nut on the axel and the hub mounting bolts.
loosen the tension on the belt with the tension pulley, remove the belt then disconnect your wires from the alternator then take the 3-4 bolts, holding the alternator on, off. then do the opposite to put the new one back on
You will need to compress the 2002 Pontiac Grand Am strut spring with a spring compressor. Remove the top and bottom strut retaining bolts. Reverse the process to install the new strut.
The 2001 Pontiac Grand Prix 3.8 liter engine intake bolt torque specification is 45 pounds. The intake bolts should be torqued in 15 pound intervals.
The license plate light bulb on a 2002 Pontiac Grand Prix is replaced by removing the retaining bolts and pulling the bulb out of its socket. A new bulb is then put into the socket and reassembled.