it depends if the tint was factory installed or if someone bought it and put it on themselves... if it was factory installed or "baked" on....good luck invest in new windows... if someone put it on themselves simply lift one of the corners and spray window cleaner in the gap while pulling on the tint it will help it to come off easier and wont leave it sticky!!
This is not an easy job. You have to remove the trim pad first. TAke it to the auto trim shop.
Remove the interioer trim and you will find two nuts to remove and the whole window trim and all will come out as you break the seal of the black gooie stuff.
Your local auto parts store can sell you the simple tools needed to help you remove the windshield trim without damaging the trim or the glass.
remove the trim that holds the window in, on the side of window frame there should be a plate, behind this is the counter weight,
The first step would be to remove the old window trim from the vehicle, and clean the surface of residue. A junk yard or dealership will be able to provide you with the replacement trim, which will need to be glued into place.
Remove the liftgate inner trim panel.Remove the liftgate inner trim panel.
purchase a 'door trim removal tool' from any auto shop and jam it under the retainer under the winder. this will allow the winder to be slid off its nipple.
It depends on the year of Mini. Often its quite simple.
Remove the front door trim panel. Remove the front window trim. Unplug the power mirror. Remove the access hole cover. Finally, remove the nuts holding the mirror to the door frame.
I M NOT A GOOD PAINTER ,I GOT PAINT ALL OVER THE WINDOW TRIM AND WALL TRIM .HOW DO I GET THAT PAINT OFF WITH OUT MESSING UP TRIM
To replace the car window on the driver side you will need to follow the following steps. 1. Disconnect the car battery if the window has automatic controls. 2. Remove the window trim and disconnect the window from manual or automatic controls. 3. Unbolt the regulator that holds the glass and remove the glass. 4. Replace the glass and reattach the regulator, controls and trim.
It's glued in. you'll need to remove the trim around the glass then cut the glue.