You have to remove the entire dash assembly.
Blower motor: remove the glove box and you will see the blower motor and blower resistor.
Remove the wiring harness from the back of your 1999 Chevy Monte Carlo blower motor. Remove the blower motor retaining bolts. Remove the fan on the front of the blower motor. Reverse the process to install the new blower motor.
remove the battery and the cpu, the blower motor will be right under it.
The blower motor is located under the dashboard behind the glove box. Remove the glove box, passenger side scat and the blower motor will be visable.
99 TRNS PORT BLOWER RESISTOROn my 98 it is under the dash on the passenger side, you have to remove the glove box, and the blower motor it is behind the blower motor with 3 crew holding it in
On the blower housing. Remove the glove box to gain access.
# Disconnect negative battery cable wait 2 minutes for airbag to disarm # Disconnect the electrical connector to the blower motor and remove the three screws retaining the blower to the housing # Pull the blower motor and fan straight out being careful not to bend the fan # To remove the fan from blower motor squeeze the spring clip together and slip the fan off the shaft
Disconnect the negative battery cable.The blower motor is located on the passenger side of the vehicle, under the instrument panel. Remove the right side sound insulator (trim panel) by removing the retainers and disconnecting the courtesy lamp.Detach the blower motor electrical connector. Some applications may have cooling hose to the motor which should be disconnected.Unfasten the blower motor mounting screws, then remove the blower motor from the vehicle.
The Blower Motor in under the dash area ubder the glovebox. You will need to remove the plastic cover to get to it. It has 3 small screws holding it in place
WHERE is the blower motor fuse on a 1999 ford e250 4.2 L
Yes
You need to remove the Rh lower insulator panel, this is the panel with the courtesy lamp. remove the push pin retainers to the panel, then un clip the courtesy lamp from the panel, then remove panel. Remove blower motor connector, remove 3- 5.5mm screws, then lower and remove the blower motor..