0
How do you Replace oil pressure sending unit on 1993 ford ranger?
Wiki User
∙ 14y ago
1999 ranger xlt 4.0 6cyl sidestep offroad 130,000miles
After market: 454 gears,tsl bogg 33", 3" body lift, cold air intake, cross drilled rotors, billstien shocks, warn manual locking hubs, alpine deck, rockford fosgate 6" door speakers x4, fosgate comp series 150 amp, 12" mtx sub, custom seat/sub box,Midland cb radio.
I bought an after market set of guages....oil press.,voltage, temp. all i did was found fittings to make a t split from engine so I could attach old oil sensor and new 1 same time so no check guages light. if you dont connect old sensor you will have annoying light forever.
It was a cheap fix(48.00) and I like the guages for the simple fact that you can really see how your engine is performing, and of course what will need to be fixed in future ..HaHa!
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the Oil pressure sending unit on a 1993 ranger v6 4.0?
On the drivers side of the engine , below the power steering pump
Where is the oilsending switch for 1993 4.0 ford ranger?
The sending unit for your oil pressure gauge is located on the drivers side of the engine , below the power steering pump on your 4.0 L - OHV engine
Where is the Oil sending unit location 1993 olds achieva?
The oil pressure sending unit is located up on the head near the pulley for the power steering pump. It is on the back side of the head. I had to replace mine. It is an easy job.
Where is the low pressure ac recharge port on 1993 Ford Ranger?
where is the low pressure port for the a/c -- 93 ford ranger 4.0L -- super-cab
What would be causing a 1993 Audi 90s to have no oil pressure I took a pressure check on the oil sending unit and had no pressure But the pump is working and there are no clogged tubes?
If you checked the pressure with the sending unit in the car, it is possible the sending unit itself may be bad!
Where is oil pressure sending unit on 1993 crown Victoria ford?
The oil sending unit on 1993 crown victory is located right under the oil filter.
Where is the oil pressure sending unit on a 1993 ford F-150 5.0L engine?
Oil pressure sending unit is right behind your oil filter base.
Where is the low side service port for a 1993 Ford Ranger?
The low pressure port on a 1993 Ford Ranger is located close to the firewall. It can be seen just under the air filter housing.
Replace timing belt in 1993 Ford Ranger 2.3 liter?
Replace every 60,000 miles. need picture diagram of 2.3 4cyl ford ranger 93 timing belt diagram
Where is ac charge valve on 1993 Ford Ranger?
The 1993 Ford Ranger air conditioning charge valve can be found on the top of the air conditioning compressor. The charge valve will be marked as the low pressure valve.
Where is the oil pressure sensor located on a 1993 Dodge Dakota?
The oil pressure sending unit is on top of the engine at the back. It is right beside of the distributor.
How do you fix a slave cylinder in a 1993 ford ranger?
you just need to hone it out and replace parts with rebuild kit.
