Turn the Idle Adjusting screw.
It's expecting the AC compressor to kick on to help the drying process. If you don't have AC, then I'm puzzled too..
Computer controlled? Not adjustable
There should be an idle screw right by or under your throttle
on top of the upper intake there is a screw. it can be used to adjust idle speed.
All Ford vehicles cannot adjust idle nor timing wich is pre-set at the factory and the computer sets the idle and timing, vehicles after 1990 no longer can be adjusted.
It is not adjustable, and is sealed from the factory and is not to be fulled with. You have another problem that is making you think idle needs adjusted.
May be computer controlled and not adjustable
You adjust idle with idle timing
Adjust idle on Mitsubishi diamante
It could be the Idle Air Control (Idle speed control) valve. Its located on the left side of your TBI and has an electrical connection.
how to adjust idle on 2001 legacy
you can adjust it via the idle control valve.
The computer does it for you through the IAC valve Idle air control its under throttle body intake hose.
you cant adjust your idle, it is computer controlled
You do not adjust the Idle Air Control as it is controlled by the computor.
its the kick down solenoid on the transmisson try replacing egr valve or pcv valve
You dont adjust the Idle disconnect the battery for 10 mins and reconnect and the computer should relearn it idle .
adjust the idle screw on the drivers side of the throttle body turn it to the right to lower you idle turn to the left to raise it
You adjust the run and idle speed with the governor wire...loosen the nut and adjust it.
At the rear of the engine on the left hand side there is an (AAV) auxiliary air valve. In front of this is a bolt sticking out. This is the idle setting bolt. Idle rpm should be 750 rpm.
How do you adjust the idle speed on a citroen berlingo 1.9d (basic diesel engine)
Answeri Have a similar problem with my 96. But there is no way to adjust the idle. i checked chiltonbook.
To adjust idle on a 1996 Yamaha Virago 110o, locate the throttle body and remove the rubber casing for the idle switch. Disconnect the idle air adjustment valve and turn the idle screw.
Idle speed is computer controlled and is not adjustable.