answersLogoWhite

0


Best Answer

The 302 is alredy balanced. You do need to install a piolet berring in the rear of the crankshaft.

User Avatar

Wiki User

18y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you balance a 1982 302 engine in a standard transmission F150 truck when it came out of an automatic transmission truck?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can you put a engine from a car with a automatic transmission in a car with a standard transmission?

Yes, but you have to remove the automatic transmission housing, and you have to replace the Torque Converter with a standard transmission clutch that matches the type of transmission with which you are mating the engine.


Where is the whole transmission located 1987 Mercury Cougar?

The question is if the transmission is a standard or an automatic, if it is a standard then the transmission is located directly behind the bell housing which is bolted onto the rear of the engine, if it is an automatic then the transmission is bolted directly to the rear of the engine


What is the towing capacity for a 2003 chevy s-10?

Standard cab with a 4 cylinder engine and automatic transmission is rated at 5600#. Standard cab with a 4.3 V6 engine and automatic transmission is rated at 6000#. Extended cab with 4.3 V6 engine and automatic transmission is rated at 5500#.


What transmission does a 2000 Chevy S-10 have?

Depends on which engine it has and if it is a standard or an automatic.


What is the timing for a 1970 250 Chevy engine?

Assuming this is a truck, if it has a standard transmission, TDC. If it has a automatic transmission, 4 degrees BTDC.


Will the wire harness on a standard transmission work with an automatic transmission in a 91 Mercury Capri?

yes it will i just had an automatic engine installed in my manuel car. and used the old harness


Will a 1994 Mazda 626 transmission fit a 1993 probe?

assuming they are the same engine/transmission configuration (ie: 4cyl automatic or 6cpy standard or 4cyl standard or 6 cyl automatic) they are the same and should be interchangeable


You just repalced the engine in a 97 escort The engine runs fine but when the car is put in gear the engine and transmission shake from side to side What could be causing this?

if the car is an automatic, there is a problem with your torque converter if it is a standard shift the fly wheel may be out of balance


Where do you set the distibutor to time a 1970 Roadrunner with 383 engine?

With a standard transmission, TDC. With an automatic transmission, 2 1/2 BTDC.


Where is the transmission dipstick for a 1987 LS Acura?

1) Is it a standard transmission or automatic engine? 2) Front wheel drive or rear wheel drive? If it is a standard transmission, you wont have a dip stick. if it is an automatic front wheel drive, it'll be on driver's side front.


Do you check the transmission fluid in a Taurus with the engine on or off?

automatic....engine warm and running while in park, standard, engine off. But this is covered in your owner's manual


What is the bell housing?

It is located between the back of the engine and the transmission. It houses the flywheel and clutch if it is a standard or the flex plate and the torque converter if it is an automatic transmission.