You need two people. lift the truck and find the slave cylinder. It should be on the drivers side of the bell housing. Pump the clutch up a few times and hold it to the floor. While holding to the floor have your partner crack the bleeder. Air or fluid should come out. Tighten the bleeder and pump the clutch up again, hold to the floor and crack the bleeder again. You may have to do this several times. If it does not bleed your problem may be else where.
how do I bleed the clutch system in a 2004 ford ranger
well mines not a ranger its a ford f250 super cab 7.5 l now how do i stop the clutch pedle from going to the floor
how to i change a clutch in a 1993 ford ranger
It should be on the bell housing above the hydrolic hose, mine had a rubber cap covering it.
How to replace a clutch interlock switch on a 1997 Ford Ranger XLT
you don't adjust it. It is a Hydraulic clutch unit. you have to bleed it. There is a 7/16" bleeder valve on the transmission. clay Colorado
On the drivers side of the transmission bellhousing Check out : www . the ranger station . com ( no spaces ) Click on Tech Library Under the manual transmission section they have a good write-up on how to bleed a hydraulic clutch
DOT ( 3 ) brake fluid is used for the hydraulic clutch in a Ford Ranger
Replace clutch master cylinder and bleed system,also check your slave cylinder for leaks.its bolted to your transmission,the clutch cable is connected to it.
you have to have fan clutch wrenches
A 1990 Ford Ranger may not shift into gear if the clutch is out. A clutch can be purchased at any auto parts store.
how to bleed the clutch system on ford f-250 2001 truck