Replace clutch master cylinder and bleed system,also check your slave cylinder for leaks.its bolted to your transmission,the clutch cable is connected to it.
need to replace thrust bearing
If it's coming out of a crimp joint, replace it. If it comes from a removable connection, replace the "o" rings. Glenn
2morro
yes you do,also if it has a cluch damper,you need to bleed it also,its bolted on left side firewall or just follow the line coming from clutch master cylinder.good luck.
Is the leak coming from your slave cylinder,it has two bolts holding it on,with a rubber cover,if so ,you need to replace and bleed it and your clutch damper,its on the left side of fire wall,just follow your clutch line from clutch master cylinder,20.00 for slave cylinder.,
never
It has already come out.
The clutch safety switch is on the clutch pedal shaft. It is a small black box with a plunger coming out of it. When you push the clutch down, the clutch safety switch connects the starter and it should turn over. If it doesn't you may have to replace it or adjust it. It's adjustable. Just adjust it until the red plunger is fully retracted out of the switch when the clutch pedal is pushed in all the way.
No all the past rangers are not coming back in RPM but in 2013 mega force they might
Its location is on the bracket behind the clutch pedal, I believe its a brown and white wiring coming from it.
i know when the power ranger ninja storm is coming because i rub my butt with soggy paper towels. power rangers suck.
Actually if the fluid is coming down the clutch pedal it is probably your clutch master cylinder going bad or the seal around it. No worries it is a cheap fix. If it is coming down the clutch pedal it has nothing to do with your brakes. Some people well most use brake fluid for the clutch.