Want this question answered?
left hand thread i had to take mine off on my 1993 2.4 frontera hope this helps
1993 Infiniti G20 does not have a hydrolic clutch! It has a cable, that runs under the intake stuff.
I have the same model. It is behind the right hand headlamp as you face the engine.
Pump the pedal to the floor and then screw on the cylinder.
you cant set the timing its all done within the engine control unit ecu and is done electronically
Right above the slave cylinder there is a bleeder screw. Just unsrew it and have someone hold in the clutch to start the bleed.
The kerb weight on this model is 1784kg. The max gross vehicle weight is 2550 kg. The max roof rack weight is 100 kg. Hope this helps
how to i change a clutch in a 1993 ford ranger
have someone pump clutch pedal about 3 times and hold to floor,then go to your clutch slave cylinder,its bolted on the side of transmission,with rubber cover,and open bleeder valve ,u might wanna get aclear hose that fits the bleeder valve and put other end in glass container so u can see air coming out,then bleed your clutch damper ,which is located on left side firewall.
Some cars have no valve and you have to loosten the line to bleed the cyl. Fill the slave cyl as full as you can get it before mounting it .
On the drivers side of the transmission bellhousing Check out : www . the ranger station . com ( no spaces ) Click on Tech Library Under the manual transmission section they have a good write-up on how to bleed a hydraulic clutch
follow the line from the master cylinder for the clutch usually there is a bleeder screw on the fire wall a couple feet from cyclinder, get some one to pump the clutch as you would bleeding the brakes, then theres a nother bleeder screw b4 the line goes to the flexline by the trans